JAMARA AMG SL 65 Ride-on Mercedes-Benz Car Instructions

JAMARA AMG SL 65 Ride-on Mercedes-Benz Car

General information

JAMARA e.K. is not liable for any damage caused to the product itself or through this, provided this is due to improper operation or handling errors. The Customer alone bears the full responsibility for the proper use and handling, including without limitation, the assembly, the charging process, the use and choice of the operation area. Please refer to the operating and user instructions, it contains important information and warnings

Suitable for children over 3 years.
Warning: Not suitable for children under 36 months. RISK OF SUFFOCATION!
Contains small parts which can be swallowed. Keep away necessarily from children
Due to its top speed this toy is not suitable for children under 3 years!

• Before playing, remove all protective films from all parts
• This product is not intended for use by individuals (including children) with reduced physical, sensory or mental capabilities or lack of experience and / or knowledge.
• Depending on development, a minimum age of 4 years could be appropriate
• Maximum weight: < 30 kg

Before assembly

• Adult required for assembly. Keep children away while assembling.
• Tools (not included) needed for assembly: screwdriver.

Certificate of Conformity
Hereby JAMARA e.K. declares that the products “Mercedes-AMG SL 65, No. 460294, No. 460295, No. 460296“ comply with Directives 2014/35/EU, 2014/53/EU, 2011/65/EU and 2009/48/EC.
The full text of the EU Declaration of Conformity is available at the following Internet address: www.jamara-shop.com/Conformity

• Read the complete instructions and security instructions carefully before using the model
• To prevent accidents and injuries, DO NOT leave your Child unattended during operation of the vehicle. Never let your Child out of your sight while the driving a vehicle
• To prevent accidents and injuries, DO NOT leave your Child unattended during operation of the vehicle. Never let your Ch ild out of your sight while the driving a vehicle
• The model stops after releasing the accelerator, independently on a horizontal
  surface.
  The vehicle has no brake or parking brake. Do not operate the vehicle uphill or downhill, and secure it when parking

DANGER

• For safe driving, you should make sure that your Child understand and adheres to the
  following rules:

  • Always sit tight, do not get up during the ride.
  • Never take additional Children for a ride. (The vehicle is only suitable for 1 person)
  • Hold tight.
  • Never drive without shoes.
  • Never drive in the dark.
  • To be used with protective equipment.

• Keep hands, hair, loose clothing and any other item away from any rotating parts.

• The Model should not be used in rooms or halls with high humidity, in the rain or on wet surfaces. Risk of malfunction or damage to electronics and housing.

• The model is not water- or splash-proof. Only operate on asphalted surfaces (such as paving stones). The model is not suitable to be operated in grass or loose soil.

Attention!
Keep the not mounted kit away from small children as it contains swallowable parts. It must be assembled or checked by adult to make sure the car is assembled on the right way before playing.

Only use in direct supervision of an adult!
To control the vehicle a minimum skill level and caution is needed. Make sure you are familiar with the operation of the model and its characteristics. The model is heavy. This is an increased risk of injury and damage in the event of loss of control. Avoid any kind of intentional or unintentional collisions with objects or hazards to persons.

**Parts

**

1. Chassis
2. Driving wheels
3. Front wheel
4. Washer Ø 10 mm
5. Nut
6. Wheel cover
7. Rearview mirror
8. Windshield
9. Seat
10. Screw Ø 4 X 12 mm
11. Steering wheel
12. Safety pin M5 x 45
13. Nut Ø 5 mm
14. Charger
15. Transmitter
16. Spanner

Dimension

Attach the left Rear Wheel

• Turn the body over
• Slide the driving wheel (2) onto the rear axle. And keep the driving wheel match with the gear box.
• Slide the Washer (4) onto the rear axle.
• Tighten a Locknut (5) to the end of the rear axle with a spanner.
• Fit the Wheel cover (6) to the wheel. Repeat for the other side.

Attach the Front Wheels

• Slide a washer (4) onto the front axle.
• Slide the normal wheel (3) onto the front axle and slide a washer (4) onto the front axle.
• Tight a Locknut (5) to the end of the front axle with a spanner.
• “Snap” the wheel cover (6) to the wheel. Repeat this step for the other side.

Steering wheel assembly

Connect the cable from the steering wheel to the cable of the dashboard (3.1). Install the steering wheel (11) in the Intended position and secure it with the Safety pin (12) and nut (13)

Attach the view mirrors and the windshield

4. Install wing mirror (7) to the designated position, and fasten it.

Insert the tabs on the windshield (8) in the slots on the vehicle body, push until you hear it click into place.

Attach Seat
Position the seat (9) over the vehicle body, by inserting the pins on the seat into the body. Tighten two M4 x 12 machine screws (10) with a screwdriver.

Assembly for adjusting the seat

• Position the seat so the seat rails slide into the rails on the model (7.1)
• Press the button (7.2) below the seat and slide the seat backwards

CAUTION: Make sure that the seat locks into place while adjusting. The seat can be locked in three different positions.

Battery connection

• Open the boot lid and connect the battery with the cable of the body.
• Only plug matching connectors into eachother and be sure not to reverse the polarity.

Charging Your Vehicle

• The power swich must be turned in OFF position when charging.
• Insert the charger into the socket – the LED lights up green. Connect the charger to the charging socket.
• The LED on your charger lights up red as long as the battery is being charged. If the LED lights green again, the battery is fully charged.
• The charge time is 9 hours.
• Do not charge the battery more than once within 24 hours.
• Charger and battery heat up during the charging process.

Warning!

• The charger is not a toy. Only use the charger supplied.
• The battery may only be charged by or under the supervision of an adult.
• The terminals must not be short-circuited.
• The charger must be checked regularly for damage to the cable, plug, housing and other parts. If any damage is found, the charger must not be used until the damage has been repaired.
• Let the model cool off sufficiently after each use before putting it back into operation. When using an additional batteries let it cool off for minimum 15 minutes until the model is operated again. Overheating can damage the electronics or may result in fire.
• Always disconnect the model from the charger immediately after charging. Always disconnect the charger from the power supply immediately after disconnecting the model. Inserting the rechargeable model or charger after charging will result in damage tothe model, charger or the power supply (fire hazard).
• Use the charger only in dry rooms.

Functions

1. Ignition lock
   Starting model
   Put key in the ignition (1) and turn.

2. Shift Lever:
   Forward: Press the “Forward-backward switch” on the “Forward” position. Press the “Foot pedal”, the model drives forward.
   Stop: The model will brake automatically, when your child’s foot remove from the “Foot pedal”. Press the “Forward-backward switch” in the middle.
   Reverse: Press the “Forward-backward switch” on the “Backward” position. Press the “Foot pedal”, the model drives backward.
   IMPORTANT!
   Always stop vehicle when changing the speed or direction to avoid damage the gears and motor.

3. Sounds button

4. Foot pedal
   Applies power (speed) to thACe vehicle.

   • To move the car, press the pedal down.
   • To brake or slow down, release pressure from the pedal.

5.  Light button
   With the switch to turn on the lights ON or OFF

Description of the functions on the transmitter
This transmitter has following function:

1. Forward
2. Backward
3. left / right
4. Speed adjustment with delay (Approx. 3 sec.)
5. Gear indicator
6. Stop (emergency stop function)
7. Power LED

Fitting the transmitter batteries
Open the battery compartment cover on the back of the transmitter and put 2 AAA batteries making sure that it is corectly put in. Then close the cover.

Binding of transmitter and model
If the model does not respond to the transmitter, press the forwards (1) and backwards (2) buttons for about 3 sec until the Power LED (7) flashes. Now switch on the model, the Power LED is lit continuously.If this does not work, repeat the process.

Battery warning:

• Non-rechargeable batteries are not to be recharged!
• Do not open! Do not dispose of in fire! Do not mix old and new batteries!
• Do not mix alkaline batteries, standard (carbon-zinc) or rechargeable batteries!Rechargeable batteries are to be removed from the toy before being  charged!Rechargeable batteries are only to be charged under adult supervision!
• The supply terminals are not to be short-circuited!

Caution
Always switch off the model immediately after each use. Immediately after each use the battery should be disconnected from the model. The battery can be deeply discharged by leaving it switched on accidentally or leaving it plugged in. Deep discharge causes the battery to lose power or can be damaged to such an extent that charging or discharging is no longer possible or the battery can self-ignite during charging or discharging (fire hazard). Never attempt to charge or discharge deeply discharged batteries. The battery voltage should never fall below 11,9 volts to avoid deep discharge. The fully char-ged battery has a voltage of approx. 13 Volt. After use, the intact battery should be fully charged immediately after a cooling phase of at least 10 minutes but at the latest after 12 hours to avoid subsequent deep discharge by self- discharge. If the battery is not used or stored for a longer period of time, the battery should be checked for voltage (min. 12,3 volts) or damage at least every 3 months and charged or disposed of if necessary.

Disposal restrictions

Batteries and accumulators must not be disposed of in domestic waste. You are obliged to dispose of batteries (seperate collection) appropriately. After use you can return batteries free of charge to the retail store. As batteries contain substances that can be irritant, can cause allergy and are highly reactive, separate collections and proper recycling is important to the environment and to your health. If the batteries are marked with a chemical symbol Hg, Cd or Pb below the crossed-out waste bin on wheels it refers to that more than 0.0005% of mercury (Hg), more than 0.002% of cadmium (Cd) or more than 0.004% Lead (Pb) is included

Kinfo@jamara.com
www.jamara.com
Service – Tel. +49 (0) 75 65/94 12-777 service@jamara.com

References

• jamara.com
• Naslovnica - Net.hr
• t-trade.de is available for purchase - Sedo.com
• jamara.com
• Janus Trade
• Reitter Modellbau & Robotics - Zubehör, Ersatzteile, Bausätze
• Mooser T-Trade: Dein neuer Lieblings-Online-Shop für Plastik Modellbau
• Veleprodaja informatičke, foto, dječje i ugostiteljske opreme te konzumne elektronike
• FAQ - Fragen und Antworten

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>