• It is of utmost importance to assemble all of the parts according to the directions. Do not skip any steps.
• Always wear work gloves during panel sliding.
• Always wear shoes and safety goggles when working with extruded aluminium.
• If using a step ladder or power tools make sure that you follow the manufacturer’s safety advice.
• Do not touch overhead power cables with the aluminium profiles.
• Do not attempt to assemble the product in windy or wet conditions.
• Do not climb or stand on the roof.
• Dispose of all plastic bags. Keep them out of reach of small children.
• Keep children away from the assembly area.
• Do not lean against or push the products during construction.
• Do not position your product in an area exposed to excessive winds.
• Do not attempt to assemble this product if you are tired, have taken drugs or alcohol, or if you are prone to dizzy spells.
• Hot items such as recently used grills, blowtorches, etc. must not be stored in the product.
• Make sure there are no hidden pipes or cables in the ground before anchoring to the foundation.
• Make sure to anchor the product directly to a solid foundation to increase the product’s stability and wind resistance in areas with severe weather conditions. Make sure that there are no obstructions between the assembly area and the final position of the product.

When your product needs to be cleaned, use a mild detergent solution and rinse with cold clean water.
DO NOT use acetone, abrasive cleaners or other special detergents to clean the panels.
Clean the product once assembly is complete.

Selecting a site:
- Choose your site carefully before beginning assembly.
- Choose a sunny position away from overhanging trees.
- The product must be positioned and fixed on a flat-level surface.
The product must be secured directly to a solid foundation.
This is a multi-part assembly best achieved by two people. Allow at least half a day for the assembly process.
Take all components & parts out of the packages. Sort the parts and check against the content parts list.
Parts should be laid out close at hand. Keep all small parts (screws etc.) in a bowl so they do not get lost.
Please note that multi-sided profiles are used in this product. As a result, some holes in the profiles are not used during assembly.
Please review the entire instructions before starting. Carry out the assembly steps in exact order.
Please consult your local authorities if any permits are required prior to constructing the product.

IMPORTANT!

Firmly connect the product to a level surface immediately after completion of the assembly.
Anchoring this product to the ground is essential to its stability and rigidity.
It is required to complete this stage in order for your warranty to be valid.
During assembly use a soft surface below the parts to avoid scratches and damage.

When encountering this information icon during assembly, please refer to the relevant assembly step for important additional comments.

The roof window can be located only on one of the two central roof panels. $CANOPIA-702771-Anchoring-Kit-fig- $7$$
If you assemble the greenhouse with an extension module, the roof windows must be placed on panels only as specified in the manual.
Note: The selected placing will affect the next assembly steps.
Please make sure you place the profile and screws according to the window location. $CANOPIA-702771-Anchoring-Kit-fig- $8$$
If the window doesn’t close properly, please release the screws, adjust the profile, and re-tighten the screws. $CANOPIA-702771-Anchoring-Kit-fig- $9$$
Peel the film covering the panel. Make sure you install it with the UV-protected side out. $CANOPIA-702771-Anchoring-Kit-fig- $10$$
Choose the appropriate anchoring according to the existing base. Screws and masonry anchors are not supplied. $CANOPIA-702771-Anchoring-Kit-fig- $11$$ $CANOPIA-702771-Anchoring-Kit-fig- $12$$ $CANOPIA-702771-Anchoring-Kit-fig- $13$$ $CANOPIA-702771-Anchoring-Kit-fig- $14$$