KOHLER 32379-PE01 10 Inch One-Light Pendant Installation Guide
- June 9, 2024
- Kohler
Table of Contents
32379-PE01 10 Inch One-Light Pendant
Installation Guide
PREPARATION
- Record your model number for future reference.
- DANGER: Risk of electric shock. To avoid electric shock,the goner must to t ur red off at the circuit breaker or fuse box before beginning the instal bib n procedure.
- DANGER: Risk of electric shock. To avo id electric s hock, t he outlet box must be properly grounded.
- Important Info rmatio n. Inspect the prod uct for any damage. This product is for irdcor use only. Obse nie all Iccal codes.
Please see next page fora larger Irstallation image
TOOLS AND MATERIALS NEEDED
FIXTURE INSTALLATION
- Remove the fixture and parts bag(s) fiomthe carton. Put themonto a can and soft cloth to protect finkh.Confirmall parts are Included.
- Determine what he€ht you want the fixture to rest at by mixing and matching the down rods (H, I, 1, and K).
- Thread wire and ground wire (L) t hro ugh des ired down rods (H, I, 1, and K). Then tightenthe desired rods together and attach to base structure (M).
- Loosen ball nuts (G) and rent* mounting plate (B) from ca no py (F).
- Thread wire and ground wire (L) through canopy (F), ball joint (E), mounting plate (8). Tthten ball joint (E) onto the to pdown rod (shown as H). Tale care not to have canopy (F) Scratch downrod during this
- Trim excess cord to minimum 1.3″ beyond canopy (F). Strip wires to 5L/8″ at the erd,and twist.
- Attach mounting plate (B) onto outlet boa with screws (13). Ensure ground screw (C) is attached to mounting plate (El) as shown.
- NOTICE: To avo Id short circuit, male sure wires are not exposed. Fasten fixture green or bare ground wire to the green or bare copper wire in outlet box with wire nut (A) orfasten onto gro und screw (C)o n mounting
- NOTICE: Toavo id short circuit, male sure wires are not exposed. Fasten fbcturewhite wire to the white wire ‘flout let boa with wire nut (A).Wra p the wire connector withele ctrical tape so that the tape seals the end of wire nut (A). See d iagram 1.
- NOTICE: To ava id short circuit, male sure wires are not exposed. Fasten the fixture black wire to the black wire in outlet box with wire nut (A). Wra p t he wire connector with electrical tape so that the tape seals the end of wire nut (A). See diagram 1.
- Tuck wiles carefully Inside outlet box. Put hall joint (E) onto canopy (F). Please rote that the notch in canopy (F) should rest in the slot in ball pint (E). Lift the fixture then attach the canopy (F) onto mounting plate (8) with ball nuts (G).
- NOTICE: Do not exceed recommended wattage. Rated Max 60W, 126, type T. (Bulb(s) not included).
- Install bulb to the socket.
- Tighten glass shade (N) onto base structure (M).
- Restore powertocircuitat breaker or fuse box.
CLEANING: Pease clean fixture with a soft and dry cloth ONLY. Clean glass wit ha mild soap.
USA,Ca recd 180 4 K0HLE
www.kohler.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>