PROGRESS LIGHTING P8720-31 Mixed Material Linear Inline Connector Instruction Manual
- June 9, 2024
- PROGRESS LIGHTING
Table of Contents
P8720 31 Mixed Material Linear
Inline Connector
Instruction Manual
Assembly & Installation Instructions
CAUTION: Read instructions carefully and turn electricity off at main
circuit breaker panel before beginning installation.
8720, 9115
IMPORTANT SAFETY INSTRUCTIONS
SAVE THESE INSTRUCTIONS
REFER TO THEM WHEN ADDITIONS TO OR CHANGES IN THE TRACK CONFIGURATION ARE
MADE
WARNING – This product contains chemicals known to the State of
California to cause cancer, birth defects and /or other reproductive harm.
Thoroughly wash hands after installing, handing, cleaning, or otherwise
touching this product
– This track accessory is to be used with Progress track only.
– Do not attempt to power this track accessory with any form of power supply
cord from a wall receptacle, or to attach any ormn of convenience receptacle
to this track accessory.
– Use of this track systern with dimmers, tiring controls, energy saving
devices, special security switching, or other devices could create a safety
hazard. Obtain professional advice before using this track system with ather
devices.
WHEN INSTALLING OR USING THIS TRACK ACCESSORY, BASIC SAFETY PRECAUTIONS
SHOULD ALWAYS BE FOLLOWED INCLUDING:
– Read all instructions and turn off electricity at main fuse box or circuit
breaker before installing, adding lo, or changing the configuration of the
track. Also, disconnect electrical power at the fuse box or circuit breaker
before servicing or relamping.
– Do not install this track accessory in a damp or wet location, or less than
5 feet above the floor, Track must be installed in a location and a manner
consistent with its intended use and in compliance with the National
Electrical Code and with all local electrical codes, Track must be grounded to
avold potential electrical shock or other potential hazards, Polarity must be
maintained throughout the installation.
– Do not use this track accessory for other than its intended use. To reduce
the risk cf fire and electric shock, do not attempt to connect power tools,
extension cords, appliances, and the like to this track accessory.
– Do not install any track lighting fixture assembly or accessory closer than
six (6) inches from arry curtain or similar combustible material.
– All servicing must be performed by qualified service personnel,
STRAIGHT TRACK CONNECTION
WARNING: Do nat turn on pcwer to track until connectors have been fully installed in all track sections. Exposed conductors become electrically LIVE and DANGEROUS immediatly when power is turned on.
-
Loosen Retaining Screws (1) and insert Connector {2) into Track (3). Fig. 1 (See Warming Abovel)
Note: Connector will only fit into the Track one way. -
Slide Reinforcing Bar (4) half way into the backside of the Track (3). Fig. 2
Note: Track sections cannot be assembled unlass the Polarity Notch (5) on each piece cf track is in line. -
Slide the second section of Track (6) onto the Connector (2) and Reinforcing Bar (4) and tighten the Retaining Screws (1) 1o complete the connection.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>