PROGRESS LIGHTING P9117-28 Mixed Material Linear T-connector Instruction Manual
- June 9, 2024
- PROGRESS LIGHTING
Table of Contents
P911728 Mixed Material Linear
T connector
Instruction Manual
Assembly & Installation Instructions
CAUTION: Read instructions carefully and turn electricity off at main
circuit breaker panel before beginning installation.
8736
WARNING – If any Special Control Devices are used with this Fixture, Follow
the Instructions Carefully to assure full compliance with N.E.C. requirements.
If there are any questions, contact a Qualified Electrical Contractor.
WARNING – This product contains chemicals known to the State of
California to cause cancer, birth defects and /or other reproductive harm,
Thoroughly wash hands after installing, handling, cleaning, or otherwise
touching this product.
IMPORTANT SAFETY INSTRUCTIONS
SAVE THESE INSTRUCTIONS
REFER TO THEM WHEN ADDITIONS TO OR CHANGES IN THE TRACK CONFIGURATION ARE
MADE
- This TRACK ACCESSORY is to be used with PROGRESS TRAK 1 TRACK only.
- DO NOT attempt to power this TRACK ACCESSORY with any form of power supply cord from a wall receptacle, or to attach any form of convenience receptacle to this TRACK ACCESSORY.
- Use of this TRACK SYSTEM with dimmers, timing controls, energy saving devices, special security switching, or other devices could create a safety hazard. Obtain professional advice before using this TRACK SYSTEM with other devices.
IMPORTANT SAFETY INSTRUCTIONS
WHEN INSTALLING OR USING THIS TRACK ACCSSORY, BASIC SAFETY PRECAUTIONS
SHOULD ALWAYS BE FOLLOWED INCLUDING:
- Read all instructions and TURN OFF ELECTRICITY at MAIN FUSE BOX, before installing, adding to, or changing the configuration of the track. Also disconnect electrical power at the fuse or circuit breaker, before servicing or relamping.
- DO NOT install this TRACK ACCESSORY in a damp or wet location, or less than five (5) feet above the floor. TRACK MUST be installed in a location and a manner consistent with its intended use and in compliance with the NATIONAL ELECTRICAL CODE and with other, local ELECTRICAL CODES. TRACK must be GROUNDED to avoid potential electrical shock or other potential hazards. Polarity must be maintained throughout the installation.
- DO NOT use this TRACK ACCESSORY for other than its intended use. To reduce the risk of fire and electric shock, DO NOT attempt to connect power tools, extension cords.appliances, and the like to this TRACK ACCESSORY,
- DO NOT install any TRACK LIGHTING FIXTURE ASSEMBLY or ACCESSORY closer than six (6) inches from any curtain or similar combustible material.
- All servicing, MUST be performed by qualified service personnel.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>