PROGRESS LIGHTING P8745-31 Mixed Material Linear Live End Power Feed Instruction Manual
- June 9, 2024
- PROGRESS LIGHTING
Table of Contents
Assembly & Installation Instruction
CAUTION; Read instructions carefully and turn electricity o! al maul
circuit breaker panel bef~re beginning install~lion.
WARNING – If any Special Control Devices are used with this Fixture,
Follow the Instructions Carefully to assure full compliance with N.E.C,
requirements. If there are any questions, contact a Qualified Electrical
Contractor.
WARNING – This product contains chemicals known to the State of
California to cause cancer, birth defects and /or other reproductive harm.
Thoroughly wash hands after installing, handling, cleaning, or otherwise
touching this product.
- This TRACK ACCESSORY is to be used with PROGRESS TRAK 1 TRACK only.
- DO NOT attempt to power this TRACK ACCESORY with any form of power supply cord from a wall receptable, or to attach any form of convenience receptable to this TRACK.
- Thls TRACK ACCESSORY is to be supplied by a single branch circuit such as a 120 volt circuit with a grounded neutral.
- Use of this TRACK SYSTEM with dimmers, timing controls, energy saving devices, special security switching, or other devices could creat a safety haard. Obtain professional advice before using this TRACK SYSTEM with other devices.
IMPORTANT SAFETY INSTRUCTIONS
WHEN INSTALLING OR USING THIS TRACK SYSTEM, BASIC SAFETY PRECAUTIONS SHOULD ALWAYS BE FOLLOWED INCLUDING:
- Read all instructions and TURN OFF ELECTRICITY at MAIN BREAKER box before installing, adding to, or changing the configuration of the TRACK. Also disconnect electrical power at the fuse or circuit breaker before servicing or re-lamping.
- DO NOT install this TRACK ACCESSORY in a damp or wet location, or less than five (5) feet above the floor, TRACK MUST be installed in a location and a manner consistent with its intended use and in compliance with the NATIONAL ELECTRICAL CODE and with other, local ELECTRICAL CODES. TRACK must be GROUNDED to avoid potential electrical shock or other potential hazards. Polarity must be maintained throughout the installation.
- DO NOT use this TRACK ACCESSORY for other than its intended use. DO NOT attempt to energize anything other than PROGRESS TRAK 1 TRACK from this TRACK ACCESSORY, Tobreduce the risk of fire and electric shock, DO NOT attempt to connect power tools, extension cords, appliances, and the like to this TRAK ACCESSORY.
- DO NOT install any TRACK LIGHTING FIXTURE ASSEMBLY or ACCESSORY closer than six (6) inches from any curtain or similar combustible material.
- All servicing, MUST be performed by a qualified service person.
SAVE THESE INSTRUCTIONS
Documents / Resources
|
PROGRESS LIGHTING P8745-31 Mixed Material Linear Live End Power
Feed
[pdf] Instruction Manual
P8745-31, Mixed Material Linear Live End Power Feed, Linear Live End Power
Feed, Mixed Material End Power Feed, End Power Feed, Power Feed
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>