PROGRESS LIGHTING P2613-30 Slide Fan Control Wall Plate Included Instruction Manual
- June 9, 2024
- PROGRESS LIGHTING
Table of Contents
P2613-30 Slide Fan Control
Wall Plate Included
Instruction Manual
INSTALLATION & OPERATING INSTRUCTION FOR UC9020
CEILING FAN SIDE WALL CONTROL
2613-30 & -59
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER
WARNING – This product contains chernicals known to the State of
California to cause canoer, birth defects and /or other reproductive harm.
Thoroughly wash hands after installing, handling, leaning, or otherwise
touching this product.
-
SAFETY PRECAUTIONS:
WARNING; To avoid fire, shock, and personal injury, follow all instructions carefully. Read your Owner’s Manual carefully before installing the ceiling fan control. Retain Owner’s Manual for future references. -
To avoid possible electrical shock, be sure electricity is turned aff at the main fuse box or circuit breaker panel before wiring.
-
This control is designed to operate only one ceiling fan and not an accessory light kIt. This wall control ls rated for 1.25 amps at 120 volts, If your ceiling fan is equipped with a variable speed pull chain switch control, make sure to set it at the highest speed before installing the wall control. This will avoid erratic speeds and possible damage to your ceiling fan.
-
Make certain no bare wires are exposed outside the connectors
-
All wiring must be conform to National and Local Electrical Codes. If you feel you do not have enough electrical wiring knowledge or experience, have your fan control installed by a licensed electrician. Any electrical wark not described in this manual should be performed by a licensed electrician.
-
Use of this control with some ceiling fan could result in fire, shock, and serious personal injury. Use this fan control only with capacitor speed controlled ceiling fans only.
INSTALLATION:
-
After electricity has been turned off at the main fuse box or circuit breaker panel, remove the existing wall plate and switch,
-
Proceed to make the wire connections as follows; (make sure the switch is in the “OFF’ position). Connect one of the Black wires from the UC92D wall control to the fan lead wire. Connect the second Black wire from the UC9020 wall control to the 120y AC hot wire. Use wire connectors provided to secure the connections
NOTE: Refer to the Schematic on the back of the wall control. -
Secure the UC9020 wall control to the outlet box using the two 6-32 x 3/4″ screws provided.
-
Secure the face plate over the wall control with the two 6-32 14 screws provided.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>