Laurel Mountain Boston 2 72 x 32 Acrylic Drop-In End Drain Bathtub Instruction Manual
- June 9, 2024
- Laurel Mountain
Table of Contents
LAUREL MOUNTAIN – OWNER’S MANUAL
For your installation, operation, and maintenance needs.
Whirlpools Air Baths Combo Baths Soakers
Boston 2 72 x 32 Acrylic Drop-In End Drain Bathtub
Contents | Pase | Contents | pase | ||
---|---|---|---|---|---|
Specifications | 1 &2 | Care & Cleaning | 4 | ||
Rough In Instructions | 2 | Whirlpool Operation | 5 | ||
Electrical / Wiring | 3 | Air Bath Operation | 5 | ||
Plumbing Instructions | 3 | Extra Options / Features / Warranty | 6&7 | ||
Operating Instructions | 4 | Troubleshooting | 8 |
About this Owner’s Manual
Laurel Mountain hasgalned popularity by the variety of bathtubs available and the extensive list of optionsfor each type of tub. This manual covers the installation, operation, and maintenance needs for whirlpools air baths, combo baths, and soaker tubs. If you have any questions or need additional information on your Laurel Mountain bath, you can contact our customer service depart ment Mon-Fri at 1-800-930-0050 between 6:00 am and 6:00 pm EST.
INSTALLATION WARNING
Your Laurel Mountain bathtub has been water tested prior to shipment. However, due to transportation and potential on-the-job conditions, you should NOT install this tub until performing a water test. A second water test should also be performed once the tub is in its final location prior to completing the install. The water test should include operation of any and all systems, jets, controls, etc.
Bullding material & wiring should be routed away from the pump or other heat producing parts of this tub.
- Please follow these instructions to ensure an easy and safe installation process. Unless written approval is obtained from Laurel Mountain, any deviations, additions, or deletions to your tub or its hardware will yold the warranty.
Specifications
Your Laurel Mountain tub was created to your order specifications. Thetub was constructed from a cast acrylic shell. It wasthen reinforced with a mixture of chopped fiberglass in a polyester resin applied to the backdde of the shell. The base of your unit was designed to give uniform support to thetub floor and has been pre-leveled. It meets or exceeds load-bearing and impact resistance requirements of the listed standard without evidence of crazing or cracking and with minimal deflection when installed in accordance to Laurel Mountain printed instructions.
PRIOR TO INSTALLATION
Immediately inspect your tub for any cosmetic defects or damage. If any
problems or concerns are discovered, contact Laurel Mountain on how to
proceed. DO NOT remove the bath from its shipping container until you are
ready to water-test and install. When you are prepared to remove the tub from
its carton DO NOT LIFT the
tub out by its plumbing. We also recommend cutting cardboard from the shipping
container to place inside the tub to protect its floor. Even though your tub
has been Inspected and water tested prior to shipment, it isvery important
that you perform a water test of your own to enwre all of the SB1.20
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>