PHILIPS 569095 Hue Gradient Signe Table User Manual
- June 4, 2024
- Philips
Table of Contents
User Manual
Personal wireless lighting
Sign Table 
Check if the electrical specification on the product label is in
accordance with the electrical socket
www.ph1hps-hue.com/connectproduct
Signify North America Corporation
400 Crossing Blvd, Suite 600
Bridgewater, NJ 08807, USA
Signify Canada Ltd/Signify Canada Ltee.
281 Hillmount Road,
Markham, ON, Canada L6C 2S3
Questions or Comments/ Questions ou commentaires :
1-800-555-0050
lmportado y/o distribuido en Mexico por: Signify Mexico S.A. De C.V.
Av. La Palma No. 6,
La Herradura, Hu1xquilucan,
Edo de Mexico, C.P. 52784, Mexico – RF.C. PME-620620-E84
Centro de Contacto: 01-800-508-9000
© 2021 Signify Holding
All rights reserved
www.philips-hue.com
4422 955 26021
Last update: 07 /2021
Signify North America Corporation
200 Franklin Square Drive
Somerset, NJ 08873, USA
Questions or Comments
Questions ou commentaires
1-800-555-0050
Centro de Contacto
01-800-508 9000
www.philips.com/lighting
www.philips-hue.com
4404 029 11882
Last update· 08/2020
SAFETY INSTRUCTIONS – PART B
The manufacturer advises the correct use of Luminaires (lighting fixtures)’
Therefore always follow these instructions to ensure correct and safe
installation and functioning of the luminaire and keep it for future
reference. Turn off electrical power at the main fuse or circuit breaker box
before commencing installation, maintenance, or repair. If in doubt, consult a
qualified electrician or contact your retail outlet. Ensure that you always
install the luminaire to the local electrical code. Certain regulations
indicate that luminaires should be installed by a qualified electrician.
Observe the correct color of the wiring before installation: white (N). black
(L) and green or bare copper wire (Ground). Do not connect this luminaire to a
non-grounded electrical system.
WARNING: Installing this fixture in a non-grounded electrical system could
allow metal parts of the luminaire to carry electrical current if any wires or
wire connections become broken or loose. Under this condition, anyone coming
in contact with the luminaire is subject to an electric shock which could
cause injury or death. Always use wire nuts/connectors rated for the correct
gauge and number of wires used.
CAUTION: Be certain that no bare wire strands are exposed outside of the wire
nuts/connections (if applicable). Be careful not to damage or cut the wire
insulation (covering) during installation. Do not permit wires to contact any
sharp edges. Do not remove the thermal insulation pad(s). Doing so will result
in increased temperatures and a possible risk of fire. Maintain interior
lighting with a dry cloth duster, do not use abrasives or solvents. Avoid
liquid on all electrical parts. Always consider all the technical
specifications of the luminaire. Verify the stated icons on the identification
label on the luminaire and the icons that are shown in part A of your safety
instructions.
ATTENTION: Below you will find all the explanations with numeric
reference to the icons respectively in front of these PART-B safety
instructions. Applicable icons to your fixture are shown in PART-A safety
instructions.
- This product should only be installed indoors.
- The product is suitable for outdoor usage.
- Only suitable for dry locations.
- Suitable for damp locations.
- Suitable for wet locations.
- Luminaire is suitable for base-up mounting.
- Luminaire is suitable for base down mounting.
- The luminaire is suitable for horizontal mounting.
- The luminaire is only suitable for fixing the ceiling.
- The luminaire is only suitable for fixing the wall.
- The luminaire is suitable for fixing the wall and the ceiling.
- Always observe the minimum distance between the lamp and the surface being lit as indicated on the icon.
- Free air space of at least 4 inches must be kept between the top of the shade and the bottom of the canopy.
- Immediately replace a cracked or broken safety glass and use only manufacturer-approved parts.
- Strip the wire as indicated in the diagram.
- Use a heat-resistant cable for wiring the luminaire into the mains.
- MAX… W: Only use lamps suitable for this luminaire and keep within the maximum specified wattage.
- This product is not suitable for children under 14 years.
- The Luminaire has a ground conductor identified with green insulation or bare copper wire.
- The luminaire is only suitable for a lamp with built-in safety or a low-pressure lamp. Extra safety glass is not necessary.
- The luminaire is equipped with a fuse. If the luminaire is out of order after the bulb has been replaced, the internal fuse has to be replaced. If contact with the internal wiring can be made during this operation, this should be done by a competent electrician.
- The luminaire can be used with a dimming circuit. Consult a qualified electrician for choosing the right type (especially important for low voltage luminaires).
- The Luminaire cannot be used with a dimming circuit.
- The luminaire is dimmable with the supplied dimmer ONLY. Do not connect to an additional dimmer.
- The dimmability features depend on the chosen lamp. More information on the disability features is available in the information pack provided with the bulb.
- Luminaire with time and light setting options Minimum and maximum will be shown in the icon in part A.
- The luminaire can be placed at a maximum of 20ft height.
- To reach optimal working, you have to place the luminaire at the height mentioned in the icon. The maximum and minimum reach of the detector is also mentioned in the icon in part A.
- The standard active range of vision of the detector covers the given degrees mentioned in the icon.
- Ensure that you don’t drill through electrical wires or any other obstruction in the wall or ceiling during installation!
- This luminaire contains in some places very hot parts.
- Product to be installed by two people.
- To avoid corrosion, clean the luminaire a minimum of 2 times per year with a soft cloth and a neutral detergent. (4 times in coastal or industrial areas).
- The product is for indoor use only. Do not use in wet locations, areas directly exposed to water, or outdoors.
- The product is ZigBee certified. Zigbee is an open standard for indoor wireless communication. All Philips ZigBee Certified products can be connected with other Philips ZigBee Certified products.
- Bluetooth· enabled product. The Bluetooth· word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. and any use of such marks by Signify is under license. Other trademarks and trade names are those of their respective owners. Hue Personal Wireless Lighting is a trademark owned by Signify Holding B.V. Please go to www.philips-hue.com to learn more about Hue and how to use it.
This device complies with Part 15 of the FCC Rules and with the RSS of Industry Canada. Operation is subject to the following two conditions:
- this device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This device generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions. may cause harmful interference to radio communications.
This Class B digital apparatus complies with CAN ICES-005. This digital apparatus does not exceed the Class B limits for radio-noise emissions from digital apparatus as set out in the Radio Interference Regulations of the Canadian
Department of Communications.
NOTICE: Changes or modifications made to this device not expressly
approved by Signify North America Corporation (USA) and Signify Canada
Ltd/Signify Canada tee. (Canada) (collectively “Signify”) may void the U.S.
FCC and Canadian authorization to operate this device. The advanced interface
module complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This device should be installed and operated with a
minimum distance of 20 centimeters between the radiator and your body. The
manufacturer is not responsible for any radio or TV interference caused by
unauthorized modifications to this equipment. Such modifications could void
the user’s authority to operate the equipment. However. there is no guarantee
that interference will not occur in a particular installation. If this device
does cause harmful interference to radio or television reception. which can be
determined by turning the device off and on, the user is encouraged to try to
correct the interference by one or more of the following measures: Reorient or
relocate the receiving antenna. · Increase the separation between the device
and receiver. · Connect the device to an outlet on a circuit different from
that to which the receiver is connected. · Consult the dealer or an
experienced radio/television technician for help.
Wireless Specification : Wireless RF mode frequency band: 2400-2483.5
MHz· Wireless communications protocol: IEEE 802.15.4 · Operating channels
Zigbee: channels 11 – 26 · Operating channels Bluetooth: channels 0-39
LIMITED WARRANTY: Signify warrants that this device’s hardware components
will be free from defects in material and workmanship for a period of two (2)
years from the date of purchase unless a different period is stated in or on
the packaging of the product, based on up to 3 hours average working time per
day/7 days per week when used as directed (the “Warranty Period”).
Notwithstanding the foregoing, the Warranty Period for all Energy Star-
certified products is three (3) years from the date of purchase. This limited
warranty only applies to the hardware components contained in the original
packaging. This limited warranty does not apply to any software, even if
packaged or sold with the hardware components. Signify does not warrant that
use of this device will be uninterrupted or error-free. If this device does
not conform to this limited warranty, Signify will send you, at its election.
a replacement device or refund your original price upon receipt of the
returned device, register receipt, and proof of purchase. Please call our
toll-free number, 1-800-555-0050. or
write to us (address indicated on the packaging) to find out how to return the
device. This limited warranty does not cover devices subject to accident.
neglect, abuse. misuse or acts of God. REPLACEMENT OR REFUND IS YOUR SOLE
REMEDY. EXCEPT TO THE EXTENT PROHIBITED BY APPLICABLE LAW, ANY IMPLIED
WARRANTIES ARE LIMITED IN DURATION TO THE DURATION OF THIS LIMITED WARRANTY.
LIABILITY FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES IS HEREBY EXPRESSLY
EXCLUDED. Some states and provinces do not allow the exclusion of incidental
or consequential damages. so the above limitation or exclusion may not apply
to you. This limited warranty gives you specific legal rights, and you may
also have other rights which vary from state to state and province to
province. This limited warranty is subject to and may be superseded by, our
End of Support policy to the extent Signify decides to terminate support for
this device in accordance with its End of Support policy, available here: www
.philips-hue.com/endofsupportpolicy
Philips and the Philips Shield Emblem have registered trademarks of
Koninklijke Philips N.V. Alterations in design and technical specifications
are reserved.
Quick start guide
Philips Hue serial number
www.ph1lips-
hue.corn/con11ectproduct
Signify
1.8.R.S. / C.C.R.I. Numero 10461
5600 VB Eindhoven.
the Netherlands
a:>oosoo-7 4454ns
www.philips-hue.com
3222 639 07191
Last update: 01/2021
© 2021 Signify Holding
All rights reserved
References
- Smart lighting | Philips Hue
- End of Support Policy | Philips Hue US
- Sustainable LED lighting solutions | Philips lighting
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>