PHOENIX DOMES Cedar Hot Tub Installation Guide

PHOENIX DOMES Cedar Hot Tub Installation

1. After levelling and preparing your hot tub pad to your liking, run a thick bead of silicone caulking down the groove between the two halves of your hot tub’s base, and press them together securely to create a bond
2. Screw in the 3 long lateral ribs as shown, followed by the additional shorter center joiner
3. Begin adding one vertical stave after the next, working your way around in a circle, with the base of each stave in contact with your hot tub pad
4. Use a rubber mallet to tap in any last staves that resist forming a circle
5. Add the first lower metal barrel strap at the same height as your floor, and tighten with a pair of wrenches until the cylindrical tension posts are 80mm apart
6. Add the following two barrel straps, one of them directly in the middle, and the uppermost one equidistant to the top edge as the lower one is to the bottom edge. Then further tighten each of the 3 barrel straps a little more to achieve maximum tension
7. Position your stove towards one edge of your base, and screw down each of the attachment points on its base
8. Lay the stove panel down overtop the stove as indicated
9. Screw the stove panel down at the indicated points
10. Screw down the slatted stove gate on both ends
11. Working around in a circle, screw down the feet of the bench supports and then the joiner points on the edges of the bench surface
12. Assemble the front step using screws at the red circles indicated and capped bolts at the green circles
13. Screw in the horizontal slats of the front steps as shown
14. Align your steps with the uppermost internal bench for ease and safety when entering
15. Erect the remainder of your chimney pipe, and your hot tub is ready to fill and fire up

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>