NVX BE-FDFOCHBG3 Series Bass Enclosure Installation Guide

June 12, 2024
NVX

BE-FDFOCHBG3 Series Bass Enclosure
Installation Guide

BE-FDFOCHBG3 Series Bass Enclosure

Step 1
Bolt the included custom bracket to the floor of the trunk. Making sure to position the bracket as seen in the photo.

Step 2
Remove the 8 4mm allen key screws from the subwoofer enclosure, then remove the subwoofer from the enclosure.

Step 3
Connect subwoofer wires to the connection terminal on your BOOST box. We generally use blue for positive (red) grey for negative (black).

Step 4
Place BOOST enclosure into position on the passenger side. Make sure the back hole lines up with the threaded stud in the trunk.

Step 5
Use the supplied nut to secure the BOOST box to the side of the trunk.

Step 6
Take included hardware and secure the BOOST box into the trunk using the new screw location from the bracket in step 1.

Step 7
Wire the subwoofer in parallel for a final impedance of 2-Ohms. Red wire goes to the red terminal and the black wire goes to the black terminal.

Step 8
Load the subwoofer back into the enclosure. Fasten the 8 allen bolts. Now it’s time to enjoy you’re new BEFDFOCHBG3-VS102!

We recommend the installation of the NVX BE-FDFOCHBG3-VS102 to be performed by a professional that will have the skills and tools to ensure the job is done correctly. Please follow the steps above to get the best performance out of the BE-HYDELAG6-VSW102. Installing and mounting NVX BEFDFOCHBG3-VS102 improperly can present a serious safety hazard in the event of a collision. If you have any questions regarding installation of this product or an amplifier in this vehicle please feel free to contact NVX directly for further guidance and installation techniques.
The BOOST subwoofer enclosures are internally wired for a 2 ohm load at the speaker-wire connection terminal. Check to see if your amplifier is optimized to drive this load. The BOOST enclosures feature a NVX VSW 10″ subwoofer and are custom made for optimal performance in a ready-to-install subwoofer system.

Included in the box:

  • Fabricated bracket M6-1.00 fender nut M6-1.00 x
  • 30mm bolt M6 lock washer
  • M6 flat washer
  • (2) factory M6 10mm nuts

BE-FDFOCHBG3-VS102 B.O.O.S.T.
Series Bass Enclosure for the
2012-2018 Ford Focus 5-Door
Hatchback

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals