RICE LAKE Ishida Uni-9 Series PC Scale User Manual
- June 9, 2024
- RICE LAKE
Table of Contents
RICE LAKE Ishida Uni-9 Series PC Scale
Cleaning, Sanitizing and Inspecting Procedure
Use the following procedure to clean, sanitize and inspect the Ishida Uni-9 daily:
Supplies
-
Clean warm water
-
Isopropyl/rubbing alcohol or alcohol swabs/wipes
-
Clean cotton towels
NOTE: A blue towel indicates the use of water or water-based cleaners. Towel should be wrung out and without drips. A red towel indicates the use of Isopropyl/rubbing alcohol or alcohol swabs/wipes. -
Optional: Mild degreaser or a non-chloride-based sanitizer
IMPORTANT:
- Do not use chloride-based cleaners.
- Do not use water-based cleaners on print head or platen rollers.
Procedure
-
Hold the power button located underneath the screen/keypad for one second to trigger the POWER OFF screen.
-
Press EXEC.
-
Remove the weigh platter and clean.
-
Clean the scale exterior, beneath the weigh platter and the scale.
-
Open the printer.
-
Remove the cassette and label roll.
-
Clean any dust from the cassette.
-
Clean the black platen roller with alcohol.
-
Clean the gap prism with alcohol.
-
Load labels.
-
Clean any dust from the cassette compartment.
-
Wipe the peel sensors.
-
Clean the print head with alcohol.
-
Return the cassette to the printer.
-
Reinstall the weight platter.
-
Power on the scale using the physical key located underneath the screen/keypad (see Figure 1 on page 1).
-
Print and remove two labels. This aligns the labels with the print head.
IMPORTANT: Never leave powered off overnight. Call for service if print quality appears degraded despite proper cleaning of the print head.
-
If a remote scale base is included, remove the scale platter and wipe clean.
-
Wipe the exterior and underside of the scale clean.
© Rice Lake Weighing Systems Content subject to change without notice.
230 W. Coleman St. • Rice Lake, WI 54868 • USA
U.S. 800-472-6703 • Canada/Mexico
800-321-6703
International 715-234-9171 • Europe +31
(0)26 472 1319
www.ricelake.com