LEDone 5114179 MW Troffer Retrofit Kit Installation Guide
- June 9, 2024
- LEDone
Table of Contents
LEDone 5114179 MW Troffer Retrofit Kit
SAFETY INSTRUCTIONS
SAFETY INSTRUCTIONS: Read instructions carefully before attempting to install fixture.
- All wiring should be performed by a qualified electrician.
- Disconnect power before installing or servicing. This fixture must be wired in accordance with the National Electrical Code and applicable local codes and ordinances.
CAUTION: Risk of fire
- WARNING: Make certain power is OFF before installing or maintaining fixture. No user serviceable parts inside.
- WARNING: Lumin aire wiring and electrical parts may be damaged when drilling for installation of LED retrofit kit. Check for enclos ed wiring and components.
- WARNING: Install this kit only in luminaires that have the construction features and dimensions shown in the photographs and/or drawings and where the input rating of the retrofit kit does not exceed the input rating of the luminaire.
- Only those open holes indicated in the drawings may be made or altered as a result of kit installation. Do NOT leave any other open holes in an enclosure of wiring or electrical components.
- Do NOT make or alter any open holes in an enclosure of wiring or electrical components during kit installation.
- WARNING: To prevent wiring damage or abrasion, do NOT expose wiring to edges of sheet metal or other sharp objects to lamp holder lead wires by employing applicable connectors.
- WARNING: This fixture is ONLY suitable for indoor recessed ceiling application.
CLEANING & MAINTENANCE
CAUTION: Be sure the fixture temperature is cool enough to touch. Do NOT clean or maintain while the fixture is energized.
- Clean glass lens with non-abrasive glass cleaning solution.
- Do NOT open fixture to clean the LED. Do NOT touch the LED.
Note: These instructions do not cover all details or variation in equipment, nor do they provide for every possible situation during installation, operation or maintenance.
TROUBLESHOOTING
- Check that the line voltage at fixture is correct. Refer to wiring directions.
- Be sure the fixture is grounded properly.
WATTAGE & COLOR TEMPERATURE SELECTION: 
INSTALLATION
To mount in an insulated or non-insulated ceiling exposed flat tee grid ceiling follow the steps below.
- Remove the existing fixture frame, clear out inside of existing housing. May need to remove ballast. (Fig. 1)
- Install the bracket in the existing housing between the housing and tee-grid bar. (Fig. 2)
- Slide the bracket to both sides and make it fixed. (Fig. 3)
- Install the flat bottom side to one of the brackets. Fix the supplemental supports and connect the circuit. (Fig. 4)
- Close the retrofit fixture and secure the latch. Notice the fixture should be completely secure. (Fig. 5)
- Installed completely. (Fig. 6)
0-10V DIMMABLE WIRING:
Universal voltage driver permits operation at 120V through 277V, 50/60Hz. For
0-10V dimming, follow the wiring instructions in Fig 7.
- Connect the BLACK fixture lead to the (+) LINE supply lead.
- Connect the WHITE fixture lead to the (-) COMMON supply lead.
- Connect the GROUND wire from fixture to supply ground. DO NOT connect the GROUND of the dimming fixture to the output.
- Connect the VIOLET fixture lead to the (V+) DIM lead.
- Connect the GREY fixture lead to the (V-) DIM lead.
- The driver comes with dimmable leads. If it is unused, make sure the leads are properly capped (if applicable).
Phone: (844) LEDONE6 | Fax: 1-510-217-9461 | Web: www.ledonecorp.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>