SWIT KA-A30B B-mount Hot Swap Plate User Manual
- June 9, 2024
- SWIT
Table of Contents
SWIT KA-A30B B-mount Hot Swap Plate User Manual
KA-A30B/R30B/R31B/B30B
Hot swap plate
Ver: A
USER MANUAL
SWIT Electronics Co., LTD.
Tel: +86-25-85805753
Fax: +86-25-85805296
http://www.swit.cc
E-mail: contact@swit.cc
Congratulations on your purchase of this product. Please read this user manual carefully.
Warning
Keep below precautions in mind to avoid fire and other safety risk:
- Do not use the plate near fire or other high temperature place to avoid over-heat and other risk.
- Do not try to damage the plate housing, disassemble the plate or internal cells.
- Do not use or storage the plate outside the range of using temperature.
- Do not use broken plate.
- Do not squeeze or impact the plate housing.
- Make sure the voltage and power of using device is not over the nominal range of the plate.
- Please put the plate side away from children.
Precautions
- If the plate is off before countdown to 0, it may be under protection, put the plate side away to recover.
- The plate normally heats up when charging and using.
- Do not use the plate in the environment over 50°C.
- Keep the electrode pole clean to avoid short circuit.
- Please storage the plate in shady and dry environment, suggest to keep the remaining power of plate over 60s.
- Please follow the parameters in user manual when using.
Feature
- Provide 120s for backup battery changing;
- 200W output power for any device in any using environment;
- Support mounting one 8-S B-MOUNT battery or other power supplies to supply power to the device through 8-pin DC;
- Various output port design:D-TAP, 2-pin DC. 8-pin DC to meet customer need;
- Support ARRI accessories, double pipe clamp to install the plate;
- Three digital bars show remaining capacity;
- KA-R31B support 1 3G-SDI input and 2 3G-SDI output.
Appearance
Charging Instruction
- Charging condition: The voltage of power supply device or battery need to higher than 22V.
- Using advise: Frequent use of internal cells may decrease the remaining capacity of the plate. Continuous connect with external power supply can be fully charged up to 120s.
- Activate instruction: The plate will switch off after countdown time to 0, charge the plate to activate again
Hot Swap Function and Screen Display
- When the external power supply device (battery or adapter) is removed or the input voltage is lower than 22V, the power supply is automatically switched to the internal cells of the plate.
- After mounting external power supply device, the power supply will automatically switched to external device; Plate will read the capacity according to remaining power.
Specification
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>