LEZYNE 4710582543050 Zecto Alert Drive Bicycle Taillight User Manual
- June 5, 2024
- Lezyne
Table of Contents
LEZYNE 4710582543050 Zecto Alert Drive Bicycle Taillight
READ ENTIRE MANUAL BEFORE OPERATION to ensure proper use and care of your new
Lezyne LED light. Traffic laws mandating lighting vary from country to
country. Inform yourself about lighting laws and regulations in the country of
use. Lezyne LED lights do not conform to theGerman road traffic regulation
StVZo.
Warnings
DO NOT LOOK DIRECTLY INTO LIGHI BEAM Or shine into eyes of another.
Lezyne LED Lights have a water resistance rating of IPX7 under IEC standard
60529. Submerging the device is not recommended. If moisture does eter the
casing, air out until completely dry. DO NOT ATTEMPT TO REMOVE ELECTRONICS.
Doing so will void warranty.
Lezyne USA, Inc. does not accept any liability for injuries or other damages
resulting from the use of this product in any circumstances.
Warranty
In U.S. and U.K., Lezyne LED Lights carry a two (2) year warranty from the
original purchase date to the original owner (proof of purchase required).
Lezyne Batteries carry a six (6) month warranty from the original purchase
date. Lezyne warranties cover any manufacturing defects in materials or
workmanship. Issues not covered by warranty include normal wear & tear,
improper installation, attempting to access or modify electronics, damage or
failure due to accident, misuse, abuse and/or neglect.
For all warranty issues worldwide, please contact the retailer that sold the
product. For any warranty questions contact:
warranty@lezyne.com
Mounting
Operation
- On/Off: hold button two (2) sec.
- Mode cycle: click button
DECELERATE DETECTION: The break deceleration warning devise senses the
rate of change of bike’s speed.
Gradually slowing: LED illuminated.
Rapidly slowing: LED flashes.
MODE MEMORY: The light remains in the output setting it is switched OFF
in.
THERMAL PROTECTION: f the operating temperature of the light is too high,
the light automatically lowers the lumen output.
Run Times and Modes
Battery Indicator
LEDs located on the sides display current battery status for a few seconds
when the light is first turned on, when pressing the button to toggle between
modes and if the ON/OFF button is quickly pushed when the light is off. When
the light is on only the orange LED stays continuously lit.
Charging
Before using your Lezyne LED Light for the first time, fully charge the
battery.
To charge your light:
-
Open USB protective cover on bottom of light
-
Connect micro USB cable and light to powered USB port
-
Once charging, side LED will flash green
If battery indicator does not flash when plugged in, selected USB port may not be powered- try another USB port.
Light will be charged after 4-6 hours or when side LED illuminates solid green. -
Remove light from charger and reinstall USB protective cover-ensure USB protective cover is fully installed for water resistance
More Information
For more information on Lezyne products, visit: www.lezyne.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>