vtech 557400 Green Means Go Baby Keys Instruction Manual

June 9, 2024
vtech

557400 Green Means Go Baby Keys
Instruction Manual

Green Means Go Baby Keys™

INTRODUCTION

Thank you for purchasing the Green Means Go Baby Keys™!
This easy-to-hold car rattle includes a teethable key and slider beads that engage baby in discovery. Sounds, sights and textures keep baby entertained at home or on the go.  Shake to hear songs, sounds, melodies and phrases. Beep- beep! Let’s go!vtech 557400 Green Means Go Baby Keys -
fig1

INCLUDED IN THE PACKAGE

  • Green Means Go Baby Keys TM
  • Quick Start Guide

WARNING
All packing materials such as tape, plastic sheets, packaging locks, removable tags, cable ties, cords and packaging screws are not part of this toy, and should be discarded for  your child’s safety.

NOTE
Please save this Instruction Manual as it contains important information.

GETTING STARTED

Battery Removal and Installation

  1. Make sure the unit is turned Off.
  2. Locate the battery cover on the back of the unit, use a screwdriver to loosen the screw, and then open the battery cover.
  3. Remove old batteries by pulling up on one end of the battery.
  4. Install 1 new AAA (AM-4/LR03) battery following the diagram inside the battery box. (For best performance, alkaline batteries or fully charged Ni-MH rechargeable  batteries are recommended.)
  5. Replace the battery cover and tighten the screw to secure.

WARNING:
Adult assembly required for battery installation. Keep batteries out of reach of children.

IMPORTANT: BATTERY INFORMATION

  • Insert batteries with the correct polarity (+ and -).
  • Do not mix old and new batteries.
  • Do not mix alkaline, standard (carbon-zinc) or rechargeable batteries. Only batteries of the same or equivalent type as recommended are to be used.
  • Do not short-circuit the supply terminals.
  • Remove batteries during long periods of non-use.
  • Remove exhausted batteries from the toy.
  • Dispose of batteries safely. Do not dispose of batteries in fire.

RECHARGEABLE BATTERIES

  • Remove rechargeable batteries (if removable) from toy before charging.
  • Rechargeable batteries are only to be charged under adult supervision.
  • Do not charge non-rechargeable batteries.

PRODUCT FEATURES

  1. On/Off/Volume Selector
    To turn the unit On, slide the On/Off/Volume Selector to the Low volume or High volume position. You will hearphrases and a fun song. To turn the unit Off, slide the On/Off/Volume Selectorto the Off position.

  2. Automatic Shut-Off
    To preserve battery life, the Green Means Go Baby KeysTM will automatically shut off after approximately 30 seconds without input.
    The unit can be turned on again by pressing the puppy button.

NOTE
If the unit powers down or if the light fades out during play, please install a new battery.

ACTIVITIES

  1.   Puppy Button
    Press the Puppy Button to hear fun phrases, songs, sounds and melodies. The light will flash with the sounds.

  2. Motion Sensor
    Shake the rattle to hear fun sounds. When a song or a melody is playing, shake the rattle again to add fun sounds on the top of the song or melody. The light will flash with the sounds.

MELODIES

1. Bingo
2. The Wheels on the Bus
3. Yankee Doodle
4. Aiken Drum
5. Bicycle Built for Two
6. Diddle, Diddle Dumpling
7. The Entertainer
8. Good Morning Merry Sunshine| 9. Hot Cross Buns
10. Sur la Pont d’Avignon
11. Little Boy Blue
12. Looby Loo
13. Muffin Man
14. London Bridge
15. Pat-a-Cake
---|---

SONG LYRICS
Song 1
Hop in the car, we’re ready to go.
Start the engine, where should we go?
Buckle up, it’s time to go,
Let’s cruise all around the town.

Song 2
I shake, shake my car keys,
And jump into the driver’s seat.
Song 3
Jingle, jangle, 1-2-3.
Grab the keys.
Come on, let’s go!

CARE & MAINTENANCE

  1. Keep the unit clean by wiping it with a slightly damp cloth.
  2. Keep the unit out of direct sunlight and away from any direct heat sources.
  3. Remove the battery if the unit will not be in use for an extended period of time.
  4. Do not drop the unit on hard surfaces and do not expose the unit to moisture or water.

TROUBLESHOOTING

If for some reason the unit stops working or malfunctions, please follow these steps:

  1. Turn the unit Off.
  2. Interrupt the power supply by removing the battery.
  3. Let the unit stand for a few minutes, then replace the battery.
  4. Turn the unit On. The unit should now be ready to use again.
  5. If the unit still does not work, install a new battery.

IMPORTANT NOTE
If the problem persists, please call our Consumer Services Department at 1-800-521-2010 in the U.S., 1-877-352-8697 in Canada, or by going to our website vtechkids.com  and filling out our Contact Us form located under the Customer Support link. Creating and developing VTech products is accompanied by a responsibility that we take very seriously. We make every effort to ensure the accuracy of the information, which forms the value of our products. However, errors sometimes can occur. It is important for  you to know that we stand behind our products and encourage you to contact us with any problems and/or suggestions you might have. A service representative will be happy to help you.

CAUTION
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio  frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee  that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and receiver.
  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help

Supplier’s Declaration of Conformity
47 CFR § 2.1077 Compliance Information

Trade Name:VTech ®
Model: 5574
Product Name: Green Means Go Baby KeysTM
Responsible Party: VTech Electronics North America, L.L.C.
Address: 1156 W. Shure Drive, Suite 200  Arlington Heights, IL 60004
Website: vtechkids.com

THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS: (1) THIS DEVICE  MAY NOT CAUSE HARMFUL INTERFERENCE, AND (2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING  NTERFERENCE  THAT MAY CAUSE UNDESIRED OPERATION.

Visit our website for more information about our products, downloads, resources and more.
vtechkids.com
vtechkids.ca
Read our complete warranty policy online at
vtechkids.com/warranty
vtechkids.ca/warranty TM & © 2022 VTech Holdings Limited.
All rights reserved.
IM-557400-000
Version:0

Documents / Resources

| vtech 557400 Green Means Go Baby Keys [pdf] Instruction Manual
557400, Green Means Go Baby Keys, Means Go Baby Keys, Green Go Baby Keys, Go Baby Keys, Baby Keys
---|---

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals