Shenzhen Ground Enterprises EM-001 BT Speaker Mask User Manual
- June 9, 2024
- Shenzhen Ground Enterprises
Table of Contents
BT SPEAKER MASK (SLEEP SOUNDS)
User Manual
PACKING LIST
- BT SPEAKER MASK*1
- User manual*1
- USB charging cable*1
- Carry bag*1
PRODUCT SPECIFICATION
Bluetooth version: V5.2
Function: Bluetooth, Sleep sounds, Hands-free
Rated Voltage: 5V/100mA
Rated Power: 70mW
Speaker: 30mm
SNR: 96dB
Working Distance: 10 Meters
Battery: 3.7V/200mAh Lithium battery
Charging time: about 2.5 Hrs
Play Bluetooth music time: 6-8Hrs
Play sleep sounds time: more than 10 Hours
Product size: 450*110(MM)
Frequency response: 20Hz-20kHz
White noise source: 10 types
CHARGING FUNCTION
Use a USB cable to connect the headphone to USB charger or your computer USB
port (Micro USB to USB Cable included). There is a notification LED light in
our device, RED light shows that device is charging, Red light change into
blue light mean fully charged. ( Note: There is a hidden charging port in the
sleeping headphone that you can use it conveniently )
HOW TO CONNECT BLUETOOTH
- Turn Bluetooth off when you’re not using it.
- Long press the “ “button to turn on, the red light & blue light flash.
- Double press “ “to change mode, the blue light will flash.
- Turn on Bluetooth with your phone, find device name”IAHB33″then connect.
- You can enjoy music after Bluetooth connection.
Note: Bluetooth devices can only be paired on a one-to-one basis, you can
disconnect the Bluetooth on smart phone, or
Triple press “ “to disconnect the Bluetooth with the previous device when
connect a new device,
HOW TO FIT ON YOUR FACE
- Gently place mask over face.
- Adjust velcro length for optimal fit and comfort.
- Gently adjust nose wing for optimal light blocking.
INSIDE EARPLUG INSTRUCTION
-
Roll and compress earplug.
-
Reach over head and pull top of ear upward.
Insert tapered end quickly into ear canal. Hold plug in until fully expanded. -
Keep away from infants.
OPERATING INSTRUCTION
- Press once PLAY / STOP button to start playing, press once again to stop playing.
- Long press Vol- for previous song.
- Long press Vol+ for next song.
- Press Vol – will constantly reduce volume to the minimum.
- Press Vol+ will constantly increase volume to the max.
- Double press will choose “white noise mode” / “bluetooth mode”.
- Triple press will disconnect the Bluetooth on smart phone.
TIMER & AUTOMATIC TURN OFF
Remark: This is avaivable in both white noise mode and bluetooth mode.
- Double press the Vol+ button for the first time with one “beep”, the product enters the automatically turn off mode in one hour. Then after one hour work, the device will turn off automatically.
- Double press the Vol+ button for the second time with dual “beep”, the device will play normally and the will not turn off automatically.
- Every time the device turns on, it will play normally without timing. When last scheduled timing not finished, it will turn off automatically based on the latest scheduled timing.
BLUETOOTH HANDS-FREE CALLING
For incoming call, you can press PLAY / STOP button to answer the phone.
Tips!!!
- Make sure the Bluetooth is opening in your phone and find device name”IAHB33″and connect.
- Please take out the Bluetooth headphone before you wash it.
- Bluetooth speakers could be adjustable for all head size.
- Please check USB cable if the headphone can’t be charge.
- Please adjust the volume from your mobile or long press Vol+ if you can’t hear any sound.
- The sound may have a bit noise if there’s environmental interference.
WASHING INSTRUCTIONS
The whole product is not waterproof, just the outside sleep mask can be washable.
- Get the hidden headphone taken out from the inside holes of the sleep mask. Be caution of the cables inside of the unit, and get them out by gentle power, just in case a strong power to break it.
- Hand wash only.
- Water under 40°C ( 104°F )
- Don’t tumble dry
- Do not bleach
HEADPHONE ASSEMBLY INSTRUCTIONS
When assembling the headphones, please pay attention to the direction of the
earphones.
The mark “L” is the left side, and the mark “R” is the right side; the ones
with letters (L, R) face front, and the ones without letters face rear.
Installing it in the wrong direction will cause the volume to sound low.
FCC Statement:
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
Warning: Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.
Note: This equipment has been tested and found to comply with the limits
for a Class B Digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>