Shenzhen Ground Enterprises SP3565 Bluetooth Speaker User Manual

Shenzhen Ground Enterprises SP3565 Bluetooth Speaker

FUNCTION PANELS

| Power Button/Mode

To power on, press and hold (3 sec). Short-press to switch modes.

---|---
| Volume Up/Next Track Volume UP: Long-Press Next Track: Short- Press
| Volume Down/Previous Track Volume Down: Long-Press Previous Track: Short-Press
| Play/Pause

Short-Press to play. Press again

to pause

Bluetooth® CONNECTION

1. Power the speaker on. The speaker will automatically enter pairing mode when powered on.
2. From your device’s Bluetooth menu, select the “AV_SP3565” speaker.
3. When paired successfully, the device will make a tone to confirm the connection has been made.
4. Remember to turn the speaker off after each use.

Note: The speaker will reconnect automatically if your device has been paired previously. Depending on your device’s type and configuration, manual reconnection may be required each time.

CHARGING

1. Using a Micro-USB cable (included), insert the jack into the port on the back of the unit and then plug the USB connecter into a USB port on the power source.
2. Charge the device until the red LED indicator turns off.
3. Always disconnect the cable when charging is finished.

Note: It will take approximately 1 hour to achieve a full charge.

TROUBLESHOOTING

No power

• Recharge your speaker using the micro-USB cable. If the problem persists, try using another micro-USB cable.

No response from the unit

• Ensure your Bluetooth device supports an A2DP, AVRCP, or HFP profile.
• Check if both devices are paired and connected to each other.
• Restart the device and try to reconnect.

If this unit is exposed to too much water and stops playing, shake the water out and leave it for a few seconds.

FCC Disclaimer

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and This device must accept any interference received,
2. including interference that may cause undesired operation. The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to this equipment. Such modifications could void the user’s authority to operate the equipment.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FcC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help or assistance.

The device has been evaluated to meet general RF exposure requirements. The device can be used in portable exposure conditions without restriction.

Electronic and electrical devices disposal

This symbol indicates that electrical and electronic device is to be collected separately.

• This product is designated for a separate collection at an appropriate collection point. Do not dispose of as household waste.
• If the device uses batteries, they must be removed from the device and disposed of in an appropriate collection center.
• If the batteries cannot be removed, do not attempt to do it yourself since it must be done by a qualified professional.
• Separate collection and recycling help conserve natural resources and prevent negative consequences for human health and the environment that might
• result from incorrect disposal. For more information, contact the retailer or the local authorities in charge of waste management.

SPECIFICATIONS

• Model No: SP3565
• Working Distance: Approx. 33 ft
• Playback Time: Approx, 3,5 Hours
• Charge Time: 3 Hours
• Speaker Output Power: 3 W
• Speaker Impedance: 4 Q
• Battery: 1200mAh Lithium (rechargeable)

Manufactured by Argento SC under license from Avalanche IP LLC. Avalanche and the Avalanche logo are trademarks of Avalanche IP LLC. The Bluetooth word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. and any use of such marks by Argento SC is under license.
Designed in New York, Made in China. New York NY 10018 support@argentosc.com www.argentosc.com

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>