PYLE PT260A Home Theater BT Digital Receiver User Manual

: June 9, 2024
: Pyle

Table of Contents

SAFETY INSTRUCTIONS
Foreword
Precautions
Connecting to amplifier
Remote
Technical Specifications
Rear panel and Bluetooth function
Read User Manual Online (PDF format)
Download This Manual (PDF format)

PYLE PT260A Home Theater BT Digital Receiver User Manual

SAFETY INSTRUCTIONS

Make sure that all connections are properly connected and the main volume is set to minimum level before turning on the unit.
When more than one pair of speakers are used, (specially the main speaker output) make sure that the speakers used are of the same wattage and impedance, otherwise the unit maybe damaged under high power or long term operation.
To avoid humming sounds and unwanted noise, make sure that all the wires are properly inserted.
For speaker cords, strip off the vinyl coating and twist the wire tip. Push down the pink jack or loosen the screw terminal, before inserting the wire tip, then fasten it and tighten the screw. Be careful not to let the wires stick out of the terminal otherwise this may cause a short circuit when wires of different terminal contact each other.
After the unit is turned on, adjust the main volume to the desired level same is true with the bass and treble volume, etc.

Foreword

Thank you for purchasing this fine PYLE amplifier.
Please read this operating instruction carefully before using. It will acquaint you fully with all its features and help you enjoy your time . The product adopts the most advanced digital technique in the world. It is 4 channels with high power output, so to speak, the real acoustic centre of your family movie theatre

Features

Stereo Amplifier With A/B Speaker Output
AM/FM Radio With Digital Display Screen
Auto Scan, Memory, Radio Station PREVIOUS/NEXT control
Remote Control Included
50 Radio Station Pre-Set Memory
Volume/Balance/TREBLE/BASS Gain Control For Main Channel
VOLUME/BASS/TREBLE/ECHO Control For Microphone
Two Microphone Input Jacks
Two RCA Input Source
110/220V power switch
AM/FM Antenna Included
BT Wireless Streaming Ability
Play/Pause/PRE/Next/Stop Control for USB Function

Precautions

Power source-The unit should be connected to a power supply AC~110V/60Hz or www.pyleUSA.com AC~220V/50Hz.
Ventilation-The unit should be situated so that its location or position does not interfere with its proper ventilation. Place the unit at least 10cm away from the walls.
Water and moisture-The unit should not be used near water-for example, near a swimming pool in a wet basement, etc.
Electric shock-if a metal object, such as hair pin or needle comes into contact inside this unit, a dangerous electric shock may result. For families with children, never permit children to put anything, especially metal, inside this unit.
Enclosure removal-Never remove the enclosure. If the internal parts are touched accidentally, a serious electric shock might occur.
Abnormal smell-if an abnormal smell or smoke is detected, immediately turn the power OFF and pull out the power cord. Contact your dealer or nearest service station.

Connecting to amplifier

Remote

REMOTE INSTRUCTION

Signal input selector CD/DVD,IPOD/MP3,BT,TUNER selector
Number buttons Using for st SELECT & STORE
MEMORY After a station has been found，you can store the station by pressing the MEMORY button.
AUTO SCAN AM/FM auto scan selector，scan and store stations automatically. Can store 50 stations.
ST/MONO Stereo and mono selector.
AM/FM AM/FM selector.
/10. DISP- / DISP+ Display Down And Up
VOL- / VOL+ Master Volume Down And Up
MUTE
Mute Selector
TUNING▲ TUNING
The two keys are used to adjust to the best signal of the stations.
USB/BT Play Next
USB/BT Play Prev
USB/BT Play/Pause

Remote Control Operation

Remote control should be operated within 6 meters and the scope of 30 in front of receiver.
Make sure that there is no big obstacle between remote control and machine.
Remote sensor should be far away from the light, high amounts of light can affect its performance.

Technical Specifications

Technical	**** PT260A
Main Channel Power Output PMPO, 4 Ohms, 1KHz test THD(1KHz)	****

Front panel

Front panel 1.

POWER SWITCH
MIC BASSMIC TREBLE
ECHO CONTROL MIC INPUT JACK 1
AM/FM SELECTOR
Press to switch the power unit ON or OFF. Adjusts the bass of MIC.
Adjusts the treble of MIC. Turn the knob to adjust the MIC echo level. KARAOKE MIC connect to this jack.
PLAY/PAUSE
USB/BT play/pause
PREV <
When it is TUNER,it means the preview station;When it is USB/BT, it means the preview song.
NEXT >
When it is TUNER,it means the next station; When it is USB/BT, it means the next song.
AM/FM SELECTOR
AUTO
Automatically search the signal of tuner11. TUNING Press this key and turn the main volume control (18) to adjust the tuning.
INPUT
This is used to select the input sources: DVD/CD、TUNER、USB、BT、IPOD/MP3
KARAOKE MIC connect to this jack.
MIC VOLUME
Adjusts the volume level. Turn the knob clockwise to increase the MIC volume.
BALANCE CONTROL
Turn the knob to adjust the master balance level.
TREBLE CONTROL
Turn the knob to adjust the master treble level.
BASS CONTROL
Turn the knob to adjust the master bass level. MASTER VOLUME
CONTROL
Adjusts the volume level. Turn the knob. clockwise to increase the volume.
USB JACK

Rear panel and Bluetooth function

TUNER ANT
Connect for AM and FM antennas.
AUDIO INPUT JACKS
Connect the audio output jacks of IPOD/MP3 , CD/DV Dto these jacks.
A SPEAKER OUTPUT TERMINALS
Connect your speaker system to these terminals.
B SPEAKER OUTPUT TERMINALS
Connect your the other speaker system(s) to these terminals.
110V/220V SWITCH
According to power voltage ,push this button to the station of the110V or 220V
POWER CORD
Connect to AC 110V/60Hz&220V/50Hz outlet.