HyperX Cloud Stinger 2 Core Gaming Headset User Guide
- June 9, 2024
- HYPERX
Table of Contents
- HyperX Cloud Stinger 2 Core Gaming Headset
- Overview
- PC or Notebook
- Xbox Series X|S or PlayStation 5
- Mobile (Phone/Tablet)
- Volume Wheel
- Swivel to Mute Microphone
- Questions or Setup Issues
- FCC Compliance and Advisory Statement
- RoHS Statement
- References
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
HyperX Cloud Stinger 2 Core Gaming Headset
Overview
- A Gaming headset
- B PC splitter cable
- C DTS Headphone: X instruction card
PC or Notebook
Follow the instructions on the DTS Headphone: X instruction card to enable DTS Headphone: X.
Xbox Series X|S or PlayStation 5
Mobile (Phone/Tablet)
Volume Wheel
- Scroll up or down to adjust volume level.
Swivel to Mute Microphone
Questions or Setup Issues
Contact the HyperX support team at:
hyperxgaming.com/support/headsets
WARNING: Permanent hearing damage can occur if a headset is used at high
volumes for extended periods of time.
DTS, DTS: X, DTS Sound Unbound, Headphone: X, the DTS logo, and the DTS:X
logo are registered trademarks or trademarks of DTS, Inc. in the United States
and other countries.
© 2020 DTS, Inc. ALL RIGHTS RESERVED.
FCC Compliance and Advisory Statement
This device complies with Part 15 of the FCC rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class
B digital device, according to Part 15 of the FCC rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation.
This equipment generates, uses and can radiate radio frequency energy and if
not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try
correct the interference by one or more of the following measures:
- Reorient the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into and outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
©Copyright 2022 HyperX and the HyperX logo are registered trademarks or trademarks of HP Inc. in the U.S. and/or other countries. All registered trademarks and trademarks are property of their respective owners.
Any special accessories needed for compliance must be specified in the instruction manual.
Warning: A shielded-type power cord is required in order to meet FCC emission limits and also to prevent interference to the nearby radio and television reception. It is essential that only the supplied power cord be used. Use only shielded cables to connect I/O devices to this equipment. CAUTION: Any changes or modifications not expressly approved by the party responsible for compliance could void your authority to operate the equipment.
RoHS Statement
This product, as well as its related consumables and spares, complies with the reduction in hazardous substances provisions of the “India E-waste (Management and Handling) Rule 2016.” It does not contain lead, mercury, hexavalent chromium, polybrominated biphenyls or polybrominated diphenyl ethers in concentrations exceeding 0.1 weight % and 0.01 weight % for cadmium, except for where allowed pursuant to the exemptions set in Schedule 2 of the Rule.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>