ilight Plexineon Recessed Static Color Instruction Manual

ilight Plexineon Recessed Static Color Instruction Manual

1. PRODUCT TO BE INSTALLED BY A QUALIFIED ELECTRICIAN.
2. USE ONLY WITH CLASS 2 POWER UNIT
3. 24 VOLTS DC
4. SUITABLE FOR WET LOCATIONS
5. RECESSED MOUNT ONLY

Assembly Instructions

NOTE: Prior to installation all 24VDC wires must be present within 72” of the installation. Refer to the power supply installation instruction for additional information.

NOTE: More than one person is recommended for this installation

1. Screw end plate onto extrusion housing
   

2. If more than one extrusion housing, use two alignment pins to connect both side of the extrusion housing

INSTALLATION OPTIONS

NOTE: Use paint mask to protect extrusion housing when doing a surface/ wall finishing. Install plexineon fixtures after removing paint mask.

NOTE: Use plaster plate when doing a mud-in installation. Use paint mask to protect extrusion housing during surface/wall finishing.

Wood Blocking Installation

NOTE: Blocks are provided by other.

Mud-in Installation

Drill or punch Ø 5/8” hole into extrusion housing.
Clamp powerfeed strain relief to wire

Snap powerfeed strain relief into hole

NOTE: Drill hole on extrusion housing before install into wall/surface.

Install recessed mounting clips to fixture. Make sure they are approximately 30” apart.

Use gule to fill in all gaps between recessed mounting clips and plexineon fixture

• Peel back power cord to expose wires.Connect power supply wires to fixture wires. Waterproof wire nuts recommended in this step.
• Snap plexineon fixture with glued mounting clips into extrusion housing.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>