CANDY CFT910 Cooker Hood Instruction Manual

: June 3, 2024
: Candy

CANDY CFT910 Cooker Hood Instruction Manual

SAFETY INSTRUCTIONS

This manual explains the proper installation and use of your cooker hood, please read it carefully before using it even if you are familiar with the product. The manual should be kept in a safe place for future reference. These instructions shall also be available in an alternative format, e.g. on a website or on request from the user in a format such as a DVD.

Never to do:

Do does not try to use the cooker hood without the grease filters or if the filters are excessively greasy!
Do not install above a cooker with a high-level grill.
Do not leave frying pans unattended during use because overheated fats or oils might catch fire.
Never leave naked flames under the cooker hood.
If the cooker hood is damaged, do not attempt to use.
Do not flambé under the cooker hood.
CAUTION : Accessible parts may become hot when used with cooking appliances.
The minimum distance between the supporting surface for the cooking vessels on the hob and the lowest part of the cooker hood. (When the cooker
hood is located above a gas appliance, this distance shall be at least 65 cm)
The air must not be discharged into a flue that is used for exhausting fumes from appliances burning gas or other fuels.

Always to do:

Important! Always switch off the electricity supply at the mains during installation and maintenance such as light bulb replacement.
The cooker hood must be installed in accordance with the installation instructions and all measurements followed.
All installation work must be carried out by a competent person or qualified electrician.
Please dispose of the packing material carefully. Children are vulnerable to it.
Pay attention to the sharp edges inside the cooker hood especially during installation and cleaning.
When the cooker hood is located above a gas appliance, the minimum distance between the supporting surface for the cooking vessels on the hob and the lowest part of the cooker hood that distance must be:
Gas cookers: 75 cm
Electric cookers: 65 cm
Coal or oil cookers: 75 cm
Make sure the ducting has no bends sharper than 90 degrees as this will reduce the efficiency of the cooker hood.
Warning: Failure to install the screws or fixing device in accordance with these instructions may result in electrical hazards
Warning: Before obtaining access to terminals, all supply circuits must be disconnected.
Always put lids on pots and pans when cooking on a gas cooker.
When in extraction mode, air in the room is being removed by the cooker hood. Please make sure that proper ventilation measures are being observed. The cooker hood removes odors from the room but not steam.
The cooker hood is for domestic use only.
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent, or similarly qualified persons in order to avoid a hazard.
This appliance can be used by children aged 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision.
Warning: Before obtaining access to terminals, all supply circuits must be disconnected.
Caution: The appliance and its accessible parts can become hot during operation. Be careful to avoid touching the heating elements. Children younger than 8 years old should stay away unless they are under permanent supervision.
There shall be adequate ventilation of the room when the cooker hood is used at the same time as appliances burning gas or other fuels.
There is a fire risk if cleaning is not carried out in accordance with the instructions
Regulations concerning the discharge of air have to be fulfilled.
Clean your appliance periodically by following the method given in the chapter MAINTENANCE.
For safety reasons, please use only the same size of fixing or mounting screws which is recommended in this instruction manual.
Regarding the details about the method and frequency of cleaning, please refer to the maintenance and cleaning section in the instruction manual.
Cleaning and user maintenance shall not be made by children without supervision.
When the cooker hood and appliances supplied with energy other than electricity are simultaneously in operation, the negative pressure in the room must not exceed 4 Pa (4 x 10-5 bar).
WARNING: Danger of fire: do not store items on the cooking surfaces.
A steam cleaner is not to be used.
NEVER try to extinguish a fire with water, but switch off the appliance and then cover flame e.g. with a lid or a fire blanket.

INSTALLATION (VENT OUTSIDE)

If you have an outlet to the outside, your cooker hood can be connected as below picture by means of an extraction duct (enamel, aluminum, flexible pipe or inflammable material with an interior diameter of 120/150mm)

Before installation, turn the unit off and unplug it from the outlet
The cooker hoods should be placed at a distance of 65-75cm from the cooking surface for best effect. See Pic 1
To install onto the wall, drill 4 holes of Ø 8mm on a suitable place according with the centre distance of hole in the back of the cooker hood.See Pic 2
Insert the nut into the holes.
Insert the screws into the nuts and tight.
Put up the cooker hood onto the fixed screws.
Then use the attached accessories enclosed to turn the screws into the two holes of inside the hood, and then fix the screws to tighten the hood onto the wall.
Put the one way valve onto the cooker hood.

Method B See Pic3:

Drill 4 holes of Ø 6mm at the bottom of the hanging cupboard.
Put the one way valve on the air outlet of cooker hood, then install the cooker hood on the bottom of the cupboard, tighten the cooker hood with enclosed 4 screws.
Install the adjusted board on the bottom of the hood in order to keep out the gap between hood back and cupboard.

Noice: There are 2 methods for ventilation, including ‘ horizontal ventilation’ and ‘ vertical ventilation’. Please pay attention to the ventilation method when installation.
Horizontal ventilation: See Pic 4A, please use the cover to seal the outlet on the top, then the air can be vented from back.
Vertical ventilation: See Pic 4B, please use the cover to seal the outlet on the back, then the air can be vented from top.

Air ventilation setting

Outdoor air ventilation: Turn the adjuster to outdoor position(pic.5A), install the outlet, turn on the cooker hood, then the air will be vented from the outside outlet.
Indoor air ventilation: Turn the adjuster to indoor position (pic.5B), install the outlet cover, turn on the cooker hood, then the air can be vented from the inside outlet.

WARNING: For safety reason, please use only the same size of fixing or mounting screw which are recommended in this instruction manual.
Failure to install the screws or fixing device in accordance with these instructions may result in electrical hazards.

Start Using Your Cooker Hood

Push button
a. Press the button “Stop”, the motor is stopped then.
b. Press the button “Low”, the motor is running at low speed.
c. Press the button “Mid”, the motor is running at medium speed.
d. Press the button “High”, the motor is running at high speed.
e. Press the button “Light”, both lights start shining .Press the button again; the lights are switched off then.

TROUBLESHOOTING

Fault	Possible Cause	Solution

Light on, but motor does not work

| Fan switch turned off| Select a fan switch position.
Fan switch failed| Contact service center.
Motor failed| Contact service center.
Light does not work, motor does not work| House fuses blown| Reset/Replace fuses.
Power cord loose or disconnected| Refit cord to power outlet. Switch power outlet on.

Oil leakage

| One way valve and the outlet are not tightly sealed| Take down the one way valve and seal with sealant.
Leakage from the connection of chimney and cover| Take chimney down and seal.
Lights not working| Broken/Faulty globes| Replace globes as per this instruction.

Insufficient suction

| The distance between the

cooker hood and the gas top is too far

| Refit the cooker hood to the correct distance.
The Cooker hood inclines| The fixing screw not tight enough| Tighten the hanging screw and make it horizontal.

[](https://manuals.plus/wp-content/uploads/2022/12/CANDY-CFT910-Cooker-

Hood-Instruction-Manual_15.jpg)NOTE:

Any electrical repairs to this appliance must conform to your local, state and federal laws.Please contact the service centre if in any doubt before undertaking any of the above.Always disconnect the unit from the power source when opening the unit.

MAINTENANCE AND CLEANING

Caution:

Before maintenance or cleaning is carried out, the cooker hood should be disconnected from the main power supply.
Ensure that the cooker hood is switched off at the wall socket and the plug removed.
External surfaces are susceptible to scratches and abrasions, so please follow the cleaning instructions to ensure the best possible result is achieved without damage.

GENERAL

Cleaning and maintenance should be carried out with the appliance cold especially when cleaning.Avoid leaving alkaline or acid substances (lemon juice, vinegar etc.) on the surfaces.

STAINLESS STEEL

The stainless steel must be cleaned regularly (e.g.weekly) to ensure long life expectancy.Dry with a clean soft cloth. A specialized stainless steel cleaning fluid may be used.

NOTE:
Ensure that wiping is done along with the grain of the stainless steel to prevent any unsightly crisscross scratching patterns from appearing

CONTROL PANEL SURFACE

The inlay control panel can be cleaned using warm soapy water. Ensure the cloth is clean and well wrung before cleaning. Use a dry soft cloth to remove any excess moisture left after cleaning.

Important

Using neutral detergents and avoid using harsh cleaning chemicals, strong household detergents or products containing abrasives,as this will affect the appliance appearance and potentially remove any printing of artwork on the control panel and will void manufactures warrantee.

GREASE MESH FILTERS

The mesh filters can be cleaned by hand. Soak them for about 3 minute in water with a grease-loosening detergent then brush it gently with a soft brush. Please do not apply too much pressure, avoid to damage it . (Leave to dry naturally out of direct sun light)
Filters should be washed separately to crockery and kitchen utensils. it is advisable not to use rinse aid.

Removing the filters as the
Please do not use abrasive detergent for it will damage the hood.

INSTALLING GREASE MESH FILTERS

To install filters for the following four steps .
Angle the filter into slots at the back of the
Push the button on handle of the
Release the handle once the filter fits into a resting
Repeat to install all

CARBON FILTER

Activated carbon filter can be used to trap odors. Normally the activated carbon filter should be changed at three or six months according to your cooking habit. The installation procedure of activated carbon filter is as below.

Before installing or replacing the carbon filters, please remove power to the
Press the filter lock and remove the mesh
Turn the carbon filter on both side of the motor anti-clockwise. Replace the carbon filters with the new carbon filters.
Place the mesh filter.
Connect the power supply to the wall socket.

NOTE:

Make sure the filter is securely locked. Otherwise, it would loosen and cause dangerous.
When activated carbon filter attached, the suction power will be lowered.

BULB REPLACEMENT

[](https://manuals.plus/wp-content/uploads/2022/12/CANDY-CFT910-Cooker-

Hood-Instruction-Manual_20.jpg)Important :

The bulb must be replaced by the manufacturer, its service agent or similarly qualified persons.
Always switch off the electricity supply before carrying out any operations on the appliance. When handling bulb, make sure it is completely cool down before any direct contact to hands.
When handling globes hold with a cloth or gloves to ensure perspiration does not come in contact with the globe as this can reduce the life of the globe.

Changing the light

Use the screw driver loosen the ST4*8MM self tapping screw (2pcs) from the lighting panel, take out the lighting fixture. Open the terminal box that connected with the wire, disconnect the wire connector and replace the lamp.

ILCOS D code for this lamp is: DBS-2/65-H-120/33
– LED modules –rectangle lamp
– Max wattage: 2 W
– Voltage range: AC 110-240V
– Dimensions:

[](https://manuals.plus/wp-content/uploads/2022/12/CANDY-CFT910-Cooker-

Hood-Instruction-Manual_22.jpg)ENVIRONMENTAL PROTECTION:

This appliance is labelled in accordance with European Directive 2012/19/EU on Waste Electrical and Electronic Equipment Regulations 2013 regarding electric and electronic appliances (WEEE). The WEEE contain both polluting substances (that can have a negative effect on the environment) and base elements (that can be reused). It is important that the WEEE undergo specific treatments to correctly remove and dispose of the pollutants and recover all the materials. Individuals can play an important role in ensuring that the WEEE do not become an environmental problem; it is essential to follow a few basic rules:

the WEEE should not be treated as domestic waste;
the WEEE should be taken to dedicated collection areas managed by the town council or a registered

ln many countries, domestic collections may be available for large WEEEs. When you buy a new appliance, the old one can be returned to the vendor who must accept it free of charge as a one-off, as long as the appliance is of an equivalent type and has the same functions as the purchased appliance.NOTE:

The following shows how to reduce total environmental impact (e.g. energy use) of the cooking process).

Install the cooker hood in a proper place where there is efficient
Clean the cooker hood regularly so as not to block the
Remember to switch off the cooker hood light after
Remember to switch off the cooker hood after

INFORMATION FOR DISMANTLING

Do not dismantle the appliance in a way which is not shown in the user manual. The appliance could not be dismantled by user. At the end of life, the appliance should not be disposed of with household waste. Check with you Local Authority or retainer for recycling advice.