Lumisky STANDY W15O Luminous floor lamp User Guide
- June 3, 2024
- Lumisky
Table of Contents
Lumisky STANDY W15O Luminous floor lamp
SAFETY INSTRUCTIONS
Make sure that the installation of your lighting fixtures complies with the regulations in force. In case of doubt, we advise you to call in a professional.
SAFETY WARNING
- When assembling and using the luminaire, the power cable must not be pulled to the foot of the luminaire and must not be adjusted along the structure of the luminaire. To avoid any risk when adjusting the position of the luminaire, the power cable must be released at the joints so as to allow bending without straining the cable.
- Keep out of reach of young children. Contact with the bulb could cause severe burns.
- Do not use the product if the cable is damaged.
- Do not place near heat sources over 60°C.
- The cable or flexible outer cord of this luminaire cannot be replaced; if the cable is damaged, the luminaire must be destroyed.
- This product contains an energy class G light source.
REPLACEMENT INSTRUCTIONS REPLACEABLE COMPONENTS
Unplug the luminaire before replacing the bulb.
Do not use a higher wattage bulb than indicated on the marking on the product.
INSTALLATION INSTRUCTIONS
Before working on this luminaire, switch off the electrical circuit on which you are going to work.
INSTRUCTIONS FOR USE
-
Be sure to use the product as described in the manual. Incorrect use may damage the product or its environment.
This product is designed for indoor and outdoor use. -
The connection to the mains must be made safely. The connection must be protected against water.
-
This lamp has a pull switch on the shade.
-
For a longer service life, it is advisable to take the light in when not in use.
MAINTENANCE INSTRUCTIONS
Always unplug the luminaire before cleaning it. Clean the exterior parts only with a soft cloth.
TROUBLESHOOTING AND TECHNICAL SPECIFICATIONS
Do not dismantle the device yourself in the event of a fault. The electrical parts of this appliance may only be disassembled by an authorized person or by the manufacturer himself.
- IP44
- Supply voltage: 220-240V
- Cable length 2 meters
- Bulb supplied: E27 LED 10W 810lm 6000K
INSTRUCTIONS FOR WASTE DISPOSAL
- Recyclable packaging
- Our company contributes financially to a global system of sorting, selective collection and recycling of household packaging waste
- Product placed on the market after August 25, 2005. A separate collection for waste electric and electronic equipment (WEEE) is required
- Sort and recycle the packaging
- Product conformity with the provisions of community directives
- Class II equipment
- Replaceable LED bulb
2 years warranty
Design in France
Batimex SAS
112 RUE AMPÈRE
ZI DE LA PLAINE DU CAIRE
13830 ROQUEFORT LA BEDOULE
FRANCE
for any request : support@batimex-import.fr
Made in SPAIN.