PHILIPS HD4646 Electric Kettle Instruction Manual

PHILIPS HD4646 Electric Kettle Instruction Manual

Introduction

Congratulations on purchasing this Philips kettle! In this user manual you find all the information you need to enjoy your kettle optimally for a long time.

General Description (Fig. 1)

• A. On/off switch (I/O)
• B. Lid
• C. Spout
• D. Water level indicator
• E. Base
• F. Scale filter

Important

Read this user manual carefully before you use the appliance and save it for future reference.

Danger

• Do not immerse the appliance or the base in water or any other liquid.

Warning

• Check if the voltage indicated on the appliance corresponds to the local mains voltage before you connect the appliance.
• Do not use the appliance if the plug, the mains cord, the base or the appliance itself is damaged.
• If the mains cord is damaged, you must have it replaced by Philips, a service centre authorised by Philips or similarly qualified persons in order to avoid a hazard.
• This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
• Children should be supervised to ensure that they do not play with the appliance.
• Keep the mains cord out of the reach of children. Do not let the mains cord hang over the edge of the table or worktop on which the appliance stands. Excess cord can be stored in or around the base of the appliance.
• Only use the kettle in combination with its original base.
• Hot water can cause serious burns. Be careful when the kettle contains hot water.
• Keep the mains cord, the base and the kettle away from hot surfaces.
• Never fill the kettle beyond the maximum level indication. If the kettle has been overfilled, boiling water may be ejected from the spout and cause scalding.
• Do not open the lid while the water is heating up. Be careful when you open the lid immediately after the water has boiled: the steam that comes out of the kettle is very hot.

Caution

• Do not touch the body of the kettle during and some time after use, as it gets very hot. Always lift the kettle by its handle.
• Always place the base and the kettle on a dry, flat and stable surface.
• The kettle is only intended for boiling water. Do not use it to heat up soup or other liquids or jarred, bottled or tinned food.
• Always make sure the water in the kettle at least covers the bottom of the kettle to prevent the kettle from boiling dry.
• Depending on the hardness of the water in your area, small spots may appear on the heating element of your kettle when you use it. This phenomenon is the result of scale build-up on the heating element and on the inside of the kettle over time. The harder the water, the faster scale builds up. Scale can occur in different colours. Although scale is harmless, too much scale can influence the performance of your kettle. Descale your kettle regularly by following the instructions given in the chapter ‘Descaling’.
• Some condensation may appear on the base of the kettle. This is perfectly normal and does not mean that the kettle has any defects.

Boil-dry protection

This kettle is equipped with boil-dry protection. This device automatically switches off the kettle if it is accidentally switched on when there is no water or not enough water in it. The on/off switch stays in ‘on’ position. Set the on/off switch to ‘off’ and let the kettle cool down for 10 minutes. Then lift the kettle from its base to reset the boil-dry protection. The kettle is nowready for use again.

Electromagnetic fields (EMF)

This Philips appliance complies with all standards regarding electromagnetic fields (EMF). If handled properly and according to the instructions in this user manual, the appliance is safe to use based on scientific evidence available today.

Before first use

1. Remove stickers, if any, from the base or the kettle.
2. Place the base on a dry, stable and flat surface.
3. To adjust the length of the cord, wind it round the reel in the base.
4. Pass the cord through one of the slots in the base.
5. Rinse the kettle with water.
6. Fill the kettle with water up to the maximum level and let the water boil once (see ‘Using the appliance’).
7. Pour out the hot water and rinse the kettle once more.

Using the appliance

1. Fill the kettle with water either through the spout or through the open lid (Fig. 2).
   

2. If the lid is open, close the lid.
   Make sure that the lid is properly closed to prevent the kettle from boiling dry.

3. Place the kettle on its base, put the plug in the wall socket.

   • Set the on/off switch to ‘I’ (Fig.3).
     

   • The kettle starts heating up.

   • The kettle switches off automatically when the water has reached boiling point.
     Note: You can interrupt the boiling process by pressing the on/off switch to ‘O’

Cleaning and descaling

Always unplug the appliance before you clean it.
Never use scouring pads, abrasive cleaning agents or aggressive liquids such as petrol or acetone to clean the appliance.
Never immerse the kettle or its base in water.

Cleaning the kettle

1. Clean the outside of the kettle with a soft, damp cloth moistened with warm water and some mild cleaning agent.

Cleaning the filter

Scale is not harmful to your health but it may give your drink a powdery taste. The scale filter prevents scale particles from ending up in your drink.Clean the scale filter regularly.

1. Remove the filter from the kettle (1) and gently brush it with a soft nylon brush under a running tap (2) (Fig. 4).
   

Note: You can also leave the filter in the kettle when you descale the whole appliance (see section ‘Descaling the kettle’ in this chapter).
Note: You can also take the filter out of the kettle and clean it in the dishwasher

Descaling the kettle

Regular descaling prolongs the life of the kettle. In case of normal use (up to 5 times a day), the following descalingfrequency is recommended:

• Once every 3 months if you use soft water (up to 18dH).
• Once every month if you use hard water (more than 18dH).

1. Fill the kettle with water up to three-quarters of the maximum level and bring the water to the boil.
2. After the kettle has switched off, add white vinegar (8% acetic acid) to the maximum level.
3. Leave the solution in the kettle overnight.
4. Empty the kettle and rinse the inside thoroughly.
5. Fill the kettle with fresh water and boil the water.
6. Empty the kettle and rinse it with fresh water again.
7. Repeat the procedure if there is still some scale in the kettle.

Note: You can also use an appropriate descaler. In that case, follow the instructions on the package of the descaler.

Replacement

If the kettle, the base or the mains cord of the appliance is damaged, take the base or the kettle to a service centre authorised by Philips for repair or replacement of the cord to avoid a hazard.

You can purchase a new filter at your Philips dealer or at a Philips service centre. The table below indicates which filters are suitable for your kettle.

• Kettle type: HD4646
• Filter type: HD4987

Environment

Do not throw away the appliance with the normal household waste at the end of its life, but hand it in at an official collection point for recycling. By doing this, you help to preserve the environment **(Fig. 5).

**

Guarantee & service

If you need service or information or if you have a problem, please visit the Philips website at www.philips.com or contact the Philips Consumer Care Centre in your country (you find its phone number in the worldwide guarantee leaflet). If there is no Consumer Care Centre in your country, go to your local Philips dealer.

www.philips.com
100% recycled paper

References

• Philips - United States | Philips
• Login

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>