Style SELECTIONS LWD5010RCB Forged Oak Vinyl Plank in the Vinyl Flooring User Guide
- June 3, 2024
- Style SELECTIONS
Table of Contents
Style
SELECTIONS LWD5010RCB Forged Oak
Vinyl Plank in the Vinyl Flooring
User Guide
LIMITED WARRANTY
General Terms:
Novalis Innovative Flooring (“Manufacturer”) warrants that, when used properly
and under normal operating conditions, the flooring products described in the
Manufacturer’s catalog as Style Selections Interlocking Vinyl Plank Flooring
(“Product”), a 5.0mm thick rigid polymeric core floating floor covering that
includes a 0.3mm (12-mil) wear layer, will conform with the published ASTM
F3261 Standard Specification for Resilient Flooring in Modular Format with
Rigid Polymeric Core, as detailed within the Manufacturer’s published Product
technical documents. This Limited Warranty is not transferable and only
applies to the original end-user (“Customer”) of the Product. This Limited
Warranty does not apply to Product that has been sold or resold as “seconds”,
“mill-run”, “off goods”, “non-conforming”, “as-is”, “closeouts” or otherwise
denoted as irregular, non-first or non-standard quality.
The Manufacturer’s liability and Customer’s exclusive remedy under this
Limited Warranty is limited to the replacement or refund of the defective
Product and, only if without visible and obvious (> 0.5-inch) defects will the
Manufacturer include reasonable labor costs for the geographic region. This
Limited Warranty does not include other costs associated with installation or
removal of the defective Product or installation of the replacement Product
including, but not limited to, lost time, furniture removal and/
or overtime pay. Only one replacement floor or refund shall be made. A
Customer who received a settlement may not make another claim – no additional
replacement floors or refund will be supplied.
If the Manufacturer no longer provides the particular Product subject to this
Limited Warranty, Manufacturer reserves the right to substitute another
Product that Manufacturer deems to be comparable or superior in its place.
Manufacturer’s responsibility to replace defective Product under this Limited
Warranty applies only to the affected area of Product so long as a suitable
match (as determined and at the sole discretion of Manufacturer) can be
supplied. Full replacement or replacement of a greater area than the affected
area is at the sole discretion of Manufacturer. Manufacturer reserves the
right to provide replacement materials directly to the Customer, or through a
professional installation company of the Manufacturer’s choice, to conduct
repairs or replace materials in a manner suitable to the Manufacturer’s
interests.
This Limited Warranty is specific to the Product which shall be installed,
used, maintained and cared for in accordance with the Product documentation,
which may be obtained at www.lowes.com or are
available upon request by contacting techsupport@novalis-
intl.com or
1-888-509-3438.
Warranty Terms & Provisions:
2.1. Manufacturing Defect Term: The Product shall be free of manufacturing
defects for a period of 1-year from the Customer date of purchase. All claims
must be reported within thirty (30) days of discovery of the defect.
2.2. Wear Warranty Term: “The Product”, when installed and maintained as
detailed within the instructions, will not wearthrough to the printed film
layer under normal use for the period stated below:
Residential Wear: | 25 years from date of purchase |
---|
Stains from unapproved chemicals, fading, scratches, scuffs, and loss of gloss
are considered normal use and are not covered under this warranty. The
Manufacturer will supply new material of the same color, design, and grade, if
available; if unavailable or discontinued, the Manufacturer reserves the right
to supply similar floor covering. After corrective action is taken on an
existing defect, Limited Warranty coverage will remain in effect for the
remaining Wear Warranty Term of the original Limited Warranty.
Alternatively, at the Manufacturer’s discretion, a refund of the original cost
of the Product shall be used to settle all other valid claims according to the
following pro-rated schedule:
Residential Wear Coverage:
≤ 1-year: 100%
≤ 5-years: 70%
≤ 10-years: 50%
≤ 20-years: 30%
20-years: 10%
2.3. Labor Warranty Term & Provisions: Labor costs shall not be reimbursed for all material installed with visible and obvious (> 0.5-inch) defects. Reasonable costs of professional labor for replacement must be submitted to and pre-approved by the Manufacturer. The percentage of labor costs that shall be reimbursed is according to the following pro-rated schedule:
Residential Labor Coverage:
≤ 1-year: 100%
≤ 5-years: 60%
≤ 10-years: 40%
≤ 20-years: 20%
20-years: 0%
2.4. Product Joint Warranty: A joint opening of a properly engaged Product
locking mechanism, as defined within ASTM F3261, shall not exceed 0.008-inch
(0.2-mm) when measured on either the width or length of the floor covering
when installed straight and over a flat substrate.
As defined within ASTM F3261, joint ledging shall not exceed 0.006 (0.15-mm),
when installed straight and over a flat substrate.
2.5. Waterproof Warranty: The Product will not be materially impaired when
exposed to wet or damp cleaning, surface spills and/or tracked in water for
the length of the Wear Warranty. This does not include water emergencies.
2.6. Wet Area Warranty: When properly installed in strict compliance with the
“Wet Area Guidelines” contained within the Product installation instructions,
the substrate or subfloor directly beneath the Product will not be damaged or
deformed by wet or damp cleaning, surface spills and/or tracked in water for
the length of the Wear Warranty. This includes visible organic growth (mold,
mildew, etc.), rot, decay or other damage that is the direct result of topical
water intrusion and exposure. This does not include excessive topical water
caused by broken or leaking plumbing, structural leaks, sink overflow,
flooding, weather conditions and other water emergencies or sub-surface
moisture or condensation related to moisture and alkalinity within the
subfloor or substrate.
2.7. Petproof Warranty: The Product surface coating provides scratch and stain
resistance (such as feces, urine and/or vomit) from domestic household pets,
such as cats and dogs, provided that pet claws are routinely cut and filed.
This Limited Warranty does not cover deliberate scratching and gouging by
pets.
Warranty Terms & Provisions:
This Limited Warranty does not apply to nor cover nonconformities that are caused by, result from or arise in connection with any of the following conditions:
- Non-Compliance with applicable Product requirements and technical data. Any Product that has been subjected to site conditions, substrate conditions, installation methods, maintenance procedures and/or conditions of use that are not in strict conformity with the associated Technical Data Sheets, Installation Instructions, Maintenance Documents, Technical Bulletins and any other relevant technical documents.
- Non-Compliance with applicable industry guidelines. Substrate preparation must be performed in accordance with all related ACI, ASTM, NWFA and RFCI guidelines.
- Installation of Product with unapproved installation materials, methods or tools, including but not limited to the recommended underlayment type, repair products and all accessories.
- Joint failure, cracking, warping, delamination, curling, or other phenomena caused by excessive heat sources, such as prolonged direct sunlight, radiators, self-cleaning ovens and high-heat equipment.
- Fading or discoloration of the surface due to excessive UV/IR exposure.
- Stains from tracked carpet dyes, fertilizers, coal, tar, driveway sealers, oil, permanent markers, or other such contaminates.
- Restriction of the natural expansion and contraction of the flooring by any means.
- Substrate failure, movement or imperfections, including improper flatness or damage.
- Heavy static loads (>500 lbs. or > 250 PSI) and heavy point loads, such as foot traffic with stiletto heels, spikes or skates, dropped items, improper floor protectors and furniture feet/rests or floor protection and furniture feet/rests that do not make adequate flat contact with the floor covering.
- Heavy rolling loads (> 250 PSI), such as electric wheelchairs, hospital beds and rolling loads with metal wheels, hard H-type wheels or any other wheel types that do not make adequate flat contact with the floor covering.
- Damage, deformation or excessive wear caused by rolling chair traffic in areas that are not protected with a polycarbonate resilient flooring chair mat.
- All damage caused by mechanical issues, intentional abuse, misuse, negligence, structural damage, seismic activity, flooding, fires, and other emergencies, natural disasters or any circumstances beyond the reasonable control of the Manufacturer.
- All resulting health issues or property damage resulting from organic growth resulting from all types of water trapped beneath the floor covering and the latent organic material found within it, which may sponsor organic growth, such as mold, mildew, and fungi.
- Normal shade, color, gloss/sheen, or embossing texture variation, including variations between installed flooring and physical flooring samples or printed marketing materials.
- Excessive wear caused by improper maintenance, dirt, grit, and/or abrasive debris.
- Excessive moisture and alkalinity from the subfloor or substrate.
- Excessive topical water caused by broken or leaking plumbing, structural leaks, sink overflow, flooding, weather conditions and other water emergencies.
- Installations removed or replaced prior to inspection by an authorized Novalis representative.
Slip Resistance Warning:
Walking is an enormously complex activity involving many muscles, bones and
nerves, as well as kinesthetic sensory information.
There are several significant factors that directly affect slip resistance
properties, such as the type, texture and surface structure of floor covering,
surface contaminates, type of shoe soles and the walker’s weight, age, gait,
fitness level, awareness, and vision. There are no published requirements or
acceptable limits for Static Coefficient of Friction (SCOF) or Dynamic
Coefficient of Friction (DCOF) values within the resilient flooring industry,
though there may be for other flooring types. While independent test results
are available, that does not purport to address any safety concerns of slip
resistance, the accuracy of all test methods, safety thresholds, or the
measuring apparatus’ (tribometers). This includes factors outside of the
reasonable control of the Manufacturer, such as Product maintenance. No
warranty for any slip resistance properties can be provided.
Note: Walking on any vinyl floor covering in socks or similar is not
recommended, especially on stairs.
Warranty Claims:
If, within the applicable warranty period identified in Article 2.1 and 2.2,
the Customer discovers any problems or defects in the Product that may be
covered by this Limited Warranty, the Customer must notify the distributor or
the Manufacturer directly at
1-888-509-3438 (option 2) or claims
@novalis-intl.com. All claims must include a
completed claim form, along with any associated photos, invoices, pre-
installation testing reports and all independent inspection reports conducted
after problems or defects are observed or suspected.
All claims must be reported within thirty (30) days of discovery of the
problem or defect. If Manufacturer determines that the Product is covered by
this Limited Warranty, then Manufacturer shall, at its sole option, replace
the nonconforming Product or refund the appropriate percentage of the purchase
price and labor cost paid for each defective Product for the affected area,
per the associated pro-rated schedule. No warranty claims will be processed if
received more than thirty (30) days after the
applicable warranty period has ended.
Manufacturer or its designated representative shall have the right to examine
the Product and the flooring, including the right to test the flooring and/or
substrate at the installation site, with respect to any Product that is the
subject of a warranty claim.
Any removal of installed Product prior to such examination will void any and
all warranties. Manufacturer may require additional testing or verification of
any tests conducted or obtained by the Customer.
Warranty Disclaimer:
The warranties set forth herein are exclusive and in lieu of all other warranties or representations, express or implied, arising by law or custom, including the implied warranties of merchantability and fitness for a particular purpose. No agent, sales representative, dealer, distributor, contractor, installer, architect or designer has the authority to increase or alter seller’s obligations under this warranty. This Limited Warranty does give you specific legal rights; you may also have other rights, which may vary from state to state.
Limitation of Liability:
The aggregate cumulative total liability of Manufacturer hereunder, whether for breach of warranty or contract, indemnification, tort (including negligence), or otherwise, shall not exceed the original purchase price of the nonconforming Product. Manufacturer assumes no liability for labor costs in the installation or replacement of any Product with visible and obvious (> 0.5-inch) defects. In no event shall Manufacturer be liable to Customer or any other person for loss of revenue, profit or any consequential, incidental, exemplary or punitive damages directly or indirectly arising from the use of the Product, from breach of any warranty or from any other cause, whether or not Manufacturer has been informed of the possibility of such damages.
Printed in China
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>