ROTOLIGHT SmartSoft Box Installation Guide

ROTOLIGHT SmartSoft Box

1. The SmartSoft™ Box is compatible with the AEOS 2 and AEOS 2 Pro.

2.  Update your AEOS 2 or AEOS 2 Pro to the latest firmware www.rotolight.com/support

3.  You’ll need the Rotolight SmartSoft™ Box, 1x Small 1/4” knob, and 2x Large M8 knobs. TE – if you are using the AEOS yoke you do not need the 2x Large knobs Supplied with the SmartSoft™ Box.

4. Turn off the AEOS 2/AEOS 2 Pro and remove the Standard Diffuser or Barndoors if they are installed.

5. Attach the SmartSoft™ Box and secure it with a small knob, don’t fully tighten at this point.

6. Install the 2x Large M8 knobs and fully tighten them and the small knob.
   NOTE – if you have the AEOS Yoke installed now tighten the larger knobs and small knob.

7. Connect the SmartSoft™ Box control cable to the AEOS 2 / AEOS 2 Pro.

8. Turn ON the AEOS 2 / AEOS 2 Pro.

9. In CCT press the bottom left icon twice to cycle between the brightness and SmartSoft™ control.

10.  Used the on-screen slider or left Red Control dial to increase and decrease the amount of diffusion. You are now ready to shoot!

How to uninstall SmartSoft™ Box

1. To Remove the SmartSoft™ Box turn OFF the AEOS 2 / AEOS 2 Pro.
2. Disconnect the Control cable from the AEOS 2 / AEOS 2 Pro.
3. Loosen the 2x Larger knobs
4. Remove the small 1/4” knob and then the SmartSoft™ Box
5. Now you are ready to attach our other light Modifiers https://www.rotolight.com/product-category/light-modifiers/

References

• Support Centre | Rotolight
• Products Product Category | Rotolight

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>