LEDMYPLACE BD001 Solar LED Bollard Lights User Manual

LEDMYPLACE BD001 Solar LED Bollard Lights

THANKS FOR YOUR PURCHASE
PLEASE READ THESE INSTRUCTIONS CAREFULLY PRIOR TO INSTALLATION

Notes before Installation

• We recommend you always try to install this solar bollard light at the places where can get direct sunlight in order to achieve the best performance. The working time of the light is depending on charging of the battery from solar panel directly, and this will be affected by weather and season.
• The light may not work enough long time when solar panel cannot receive sufficient power from sunlight in the winter months or in very cloudy weather. Therefore, the number of hours the light stays on would be be reduced during winter.
• Make sure the solar bollard light is located in an area where the solar panel can get the maximum amount of full and direct sunlight every day. Do not install light under trees, move any debris on the top of solar panel and clean occasionally.
• If your install this solar bollard light too close to a street light, porch light or any other light it may affect the function of this light that it may not turn on automatically at night, because the built-in photocell light sensor cannot detect dark so it cannot transmit control instruction to the control unit.

How to install the light?

• Step 1 : Check surface is flat or determine how to ensure the light is perfectly vertical.
• Step 2 : Mark out the holes center points as below sizes show to suit the base plate.
• Step 3 : Drill or core holes to take an M6 threaded rod or other securing device
• Step 4 : Install rod and ensure sufficient thread protrudes from plate.
• Step 5 : Place base plate over the bolts and use spirit level when tensioning to ensure pole is set level
• Step 6 : Remove the white rubber cork and push on the button inside of the pole to activate the system.
  Then your solar light is now installed and ready for operation

DIMENSION

Common trouble shot

Light is off

| Switch is off| Push on the switch
No direct sun| Move light to sunshine place
Much cloudy or rainy days| Work again when sun comes

Short working time

| Debris on solar panel| Clean solar panel
Installation location| Adjust location
Cloudy or very rainy| Work again when sun comes
Battery life is expried| Replace the battery in remote
Remote setting is wrong| Reset the light by remote

Color is not changing when press the button of remote

| Solar light head| Switch ON/OFF light
Battery life in remote is expried| Replace the battery in remote

Key Specification

• Solar Panel : 6.2W 5V

• LED Power : 1.0W

• Luminous flux : > 220lm

• CCT : White / RGBCW

• Battery type : LifePO4

• Lifetime of Battery : 2000 cycles

• Remote : Available for RGBCW

• IP & IK Rate : IP65 IK10

• Working temp: -20°C~ +60C

• Solar Panel : 6.2W 5V

• LED Power : 1.5 W

• Luminous flux : > 260 lm

• CCT : White / RGBCW

• Battery type : LifePO4

• Lifetime of Battery : 2000 cycles

• Remote : Available for RGBCW

• IP & IK Rate : IP65

• Working temp: -20°C~ +60C

Button operation of White Version

Three colors can be set by pushing buttoon,

• First push is 3000k warm white
• Second push is 4000k day light
• Third push is 6000K cool white
• Forth push is ON/OFF.
  ( Remote is not available for white version.)

The led light source is non-user replaceable

Documents / Resources

| LEDMYPLACE BD001 Solar LED Bollard Lights [pdf] User Manual
BD001 Solar LED Bollard Lights, BD001, Solar LED Bollard Lights, LED Bollard Lights, Bollard Lights, Lights
---|---

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>