PHILIPS DDBC1200 Signal Dimmer Controller Instruction Manual
- June 3, 2024
- Philips
Table of Contents
DDBC1200
Signal Dimmer
Controller
Installation Instructions
DDBC1200 Signal Dimmer Controller
Devices must be installed in an approved enclosure by a qualified electrician in accordance with all national and local electrical and construction codes and regulations.
Control Channel Ratings
| |
---|---|---
DALI
Broadcast| ≤ 80/CH
Guaranteed 160 mA
Maximum 250 mA
Insulation: basic| ≤ 300
DSI| ≤ 80/CH| ≤ 300
0-10 V| Sink 50 mA Source 50 mA| Driver dependent
This is a class A product. In a domestic environment this product may cause
radio interference, in which case the user may be required to take adequate
measures.
Federal Communications Commission (FCC) Compliance Notice: Radio Frequency
Notice – This equipment has been tested and found to comply with the limits
for a Class A digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instruction manual, may cause
harmful interference to radio communications. Operation of this equipment in a
residential area is likely to cause harmful interference in which case the
user will be required to correct the interference at his own expense.
This Class A digital apparatus complies with Canadian ICES-003: CAN ICES-3
(A)/NMB-3(A).
© 2022 Signify Holding. All rights reserved. Specifications are subject to change without notice. No representation or warranty as to the accuracy or completeness of the information included herein is given and any liability for any action in reliance thereon is disclaimed. Philips and the Philips Shield Emblem are registered trademarks of Koninklijke Philips N.V. All other trademarks are owned by Signify Holding or their respective owners.
AZZ 370 0922 R18
www.dynalite.com