ENCELIUM PS 30 Power Supply Instruction Manual

June 3, 2024
ENCELIUM

ENCELIUM PS 30 Power Supply

GETTING STARTED

OVERVIEW

The PS 30 power supply has an output voltage of 24 VDC and output current of 1.3 A. It is suitable for a wide-range of applications and has a large input voltage range, so you are bound to find it useful in many professional lighting projects. For more information on product specifications and design tools visit encelium.com.

PRODUCT SAFETY

READ THESE INSTRUCTIONS BEFORE USING THE PRODUCT

When using electrical equipment, basic safety precautions should always be followed, including the following:

  • Do not mount near gas or electric heaters or let power supply cords touch hot surfaces.
  • Equipment should be mounted in locations and at heights where it will not readily be subjected to tampering by unauthorized personnel.
  • The use of accessory equipment is not recommended by Encelium as it may cause an unsafe condition.
  • All DALI channels are internally connected together to the control unit. Make sure to consider this when installing.
  • Do not use this equipment for other than the intended use.

SAVE THESE INSTRUCTIONS.

STEP 1
DIN RAIL MOUNT

ENCELIUM-PS-30-Power-Supply-01 The PS 30 should be vertically mounted so that the terminal block is at the top. A clearance of at least 20 mm (0.8 inch) should be maintained above and below. No space is required at the side. The PS 30 snaps onto a 35 mm (1.4 inches) DIN Rail within an electrical panel.

STEP 2
MAKE ELECTRICAL CONNECTIONS ENCELIUM-PS-30-Power-
Supply-02The Input AC is connected using terminal Line 1 (L1) and Neutral (N), and must be connected according to IEC 60364 and EN 50178. The Output DC is connected via the +24 VDC and -24 VDC terminals at the output of the power supply. Make sure that the output cables are positioned correctly for the maximum output current value.

RELEASE FROM DIN RAIL

To release the PS 30 from the DIN Rail, insert a screw driver into the release tab and pull the PS 30 forward.

FEATURES

ENCELIUM-PS-30-Power-Supply-04

The PS 30 features a LED Indicator, Potentiometer, and Measuring Point. The PS 30 24V power supply connects to a 1-phase AC system or a DC systems. The PS 30 is a power supply for the Wired Manager — DALI. The electronically regulated DC voltage can be set anywhere from 22.2 to 26.4 via a potentiometer. The LED Indicator status signals either ON or OFF.

VISIT OUR HELP CENTER

ENCELIUM-PS-30-Power-Supply-05

For instructions to install, configure, test, or use Encelium products or systems, or to contact an Encelium Technical Support Specialist, please scan the QR code or visit help.encelium.com.

Copyright © 2022 Digital Lumens, Incorporated. All rights reserved. Digital Lumens, the Digital Lumens logo, We Generate Facility Wellness, SiteWorx, LightRules, Lightelligence, Encelium, the Encelium logo, Polaris, GreenBus and any other trademark, service mark, or tradename (collectively “the Marks”) are either trademarks or registered trademarks of Digital Lumens, Inc. in the United States and/or other countries, or remain the property of their respective owners that have granted Digital Lumens, Inc. the right and license to use such Marks and/or are used herein as nominative fair use. Due to continuous improvements and innovations, specifications may change without notice.
DOC-000462-00 Rev A 11-22

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals