datavideo TTL-100 Through The Lens Kit for TLM-700 Instruction Manual

datavideo TTL-100 Through The Lens Kit for TLM-700

Disclaimer of Product and Services
The information offered in this instruction manual is intended as a guide only. At all times, Datavideo Technologies will try to give correct, complete and suitable information. However, Datavideo Technologies cannot exclude that some information in this manual, from time to time, may not be correct or may be incomplete. This manual may contain typing errors, omissions or incorrect information. Datavideo Technologies always recommend that you double check the information in this document for accuracy before making any purchase decision or using the product. Datavideo Technologies is not responsible for any omissions or errors, or for any subsequent loss or damage caused by using the information contained within this manual. Further advice on the content of this manual or on the product can be obtained by contacting your local Datavideo Office or dealer.

FCC Compliance Statement

This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired operation.

Warnings and Precautions

1. Read all of these warnings and save them for later reference.
2. Follow all warnings and instructions marked on this unit.
3. Unplug this unit from the wall outlet before cleaning. Do not use liquid or aerosol cleaners. Use a damp cloth for cleaning.
4. Do not use this unit in or near water.
5. Do not place this unit on an unstable cart, stand, or table. The unit may fall, causing serious damage.
6. Slots and openings on the cabinet top, back, and bottom are provided for ventilation. To ensure safe and reliable operation of this unit, and to protect it from overheating, do not block or cover these openings. Do not place this unit on a bed, sofa, rug, or similar surface, as the ventilation openings on the bottom of the cabinet will be blocked. This unit should never be placed near or over a heat register or radiator. This unit should not be placed in a built-in installation unless proper ventilation is provided.
7. This product should only be operated from the type of power source indicated on the marking label of the AC adapter. If you are not sure of the type of power available, consult your Datavideo dealer or your local power company.
8. Do not allow anything to rest on the power cord. Do not locate this unit where the power cord will be walked on, rolled over, or otherwise stressed.
9. If an extension cord must be used with this unit, make sure that the total of the ampere ratings on the products plugged into the extension cord do not exceed the extension cord rating.
10. Make sure that the total amperes of all the units that are plugged into a single wall outlet do not exceed 15 amperes.
11. Never push objects of any kind into this unit through the cabinet ventilation slots, as they may touch dangerous voltage points or short out parts that could result in risk of fire or electric shock. Never spill liquid of any kind onto or into this unit.
12. Except as specifically explained elsewhere in this manual, do not attempt to service this product yourself. Opening or removing covers that are marked “Do Not Remove” may expose you to dangerous voltage points or other risks, and will void your warranty. Refer all service issues to qualified service personnel.
13. Unplug this product from the wall outlet and refer to qualified service personnel under the following conditions:
    • When the power cord is damaged or frayed;
    • When liquid has spilled into the unit;
    • When the product has been exposed to rain or water;
    • When the product does not operate normally under normal operating conditions. Adjust only those controls that are covered by the operating instructions in this manual; improper adjustment of other controls may result in damage to the unit and may often require extensive work by a qualified technician to restore the unit to normal operation;
    • When the product has been dropped or the cabinet has been damaged;
    • When the product exhibits a distinct change in performance, indicating a need for service.

GLASS – Handle with care

This product contains a sheet of 60/40 mirror glass please handle it with care. To avoid a risk of damage or injury please follow this instruction manual and use caution when transporting, un-packing, cleaning, assembling or dis-assembling this part of the product.

Warranty

Standard Warranty

• Datavideo equipment are guaranteed against any manufacturing defects for one year from the date of purchase.
• The original purchase invoice or other documentary evidence should be supplied at the time of any request for repair under warranty.
• The product warranty period begins on the purchase date. If the purchase date is unknown, the product warranty period begins on the thirtieth day after shipment from a Datavideo office.
• All non-Datavideo manufactured products (product without Datavideo logo) have only one year warranty from the date of purchase.
• Damage caused by accident, misuse, unauthorized repairs, sand, grit or water is not covered under warranty.
• Viruses and malware infections on the computer systems are not covered under warranty.
• Any errors that are caused by unauthorized third-party software installations, which are not required by our computer systems, are not covered under warranty.
• All mail or transportation costs including insurance are at the expense of the owner.
• All other claims of any nature are not covered.
• All accessories including headphones, cables, and batteries are not covered under warranty.
• Warranty only valid in the country or region of purchase.
• Your statutory rights are not affected.

Register for 3 year Warranty

• All Datavideo products purchased after July 1st, 2017 are qualified for a free two years extension to the standard warranty, providing the product is registered with Datavideo within 30 days of purchase.
• Certain parts with limited lifetime expectancy such as LCD panels, DVD drives, Hard Drive, Solid State Drive, SD Card, USB Thumb Drive, Lighting, Camera module, PCIe Card are covered for 1 year.
• The three-year warranty must be registered on Datavideo’s official website or with your local Datavideo office or one of its authorized distributors within 30 days of purchase.

Disposal

For EU Customers only – WEEE Marking
This symbol on the product or on its packaging indicates that this product must not be disposed of with your other household waste. Instead, it is your responsibility to dispose of your waste equipment by handing it over to a designated collection point for the recycling of waste electrical and electronic equipment. The separate collection and recycling of your waste equipment at the time of disposal will help to conserve natural resources and ensure that it is recycled in a manner that protects human health and the environment. For more information about where you can drop off your waste equipment for recycling, please contact your local city office, your household waste disposal service or the shop where you purchased the product.

CE Marking is the symbol as shown on the left of this page. The letters “CE” are the abbreviation of the French phrase “Conformité Européene” which literally means “European Conformity”. The term initially used was “EC Mark” and it was officially replaced by “CE Marking” in the Directive 93/68/EEC in 1993. “CE Marking” is now used in all EU official documents.

Packing List

Product Overview

Features

• A low-cost accessory kit that turns the TLM-700K /TLM-700UHD into a “through the lens” monitor.
• Can be mounted to all tripods and light stands
• Can be used with web conferencing software such as Zoom for remote interviews, allows you to see your guest while looking directly into the centre of the camera lens.
• Can be used for online presentations / webinars.
• Allows the talent to see themselves while looking directly into the centre of the camera lens.
• Web cameras with ¼ threads can be mounted directly to the TTL-100
• A wide range of larger cameras can be mounted behind the TTL-100 when used freestanding The TTL-100 kit turns your Datavideo TLM-700K / TLM-700UHD into a “through the lens” monitor allowing you to see any HDMI source directly in front of the camera lens. The TTL-100 kit is ideal for maintaining eye contact when video conferencing or allowing the talent to monitor themselves while keeping their eye level centre of the camera lens.

Assembly

1. Attach the Velcro strips (Item I) to both sides of the TLM-700 monitor lip as shown.

2. Attach the cloth hood (Item G) to the Velcro strips on both sides of the TLM-700 monitor.

3. Attach the cloth support strip with press studs (Item H) to both sides of the cloth hood (Item G). Ensure the support strip is pulled tight and the hood is upright.

4. If you intend to use the TTL-100 in freestanding in front of a camera, attach the aluminium monitor bracket (Item A) to the TLM-700 monitor using the large ¼ screw (Item D).
   If you intend to mount a small box camera or webcam directly to the TTL-100, attach the aluminum monitor bracket (Item A) and the aluminum camera bracket (Item B) to the TLM-700 monitor using the large ¼ screw (Item D).

5. Insert the 60/40 mirror glass (Item J) into the hood (Item G) with the green sticker facing you and the Velcro strip at the top, the bottom of the glass should rest on top of the TLM-700 monitors lip, secure the glass with the Velcro at the top.

6. Optionally attach your small box camera or web camera to the aluminum camera bracket (Item B) using the small ¼ screw and 1.5mm rubber washer (Item F) if required. The position of the camera can be adjusted by loosening screws C a

7. Pull the weighted cloth snood over your camera and ensure there is no light entering the hood, any light entering the hood may reflect off the glass and back into the camera lens.

8. If your camera has LED lights that cannot be turned off, these can be covered using the supplied cloth strips (Item E)

9. Attach the aluminium monitor bracket (Item A) to a tripod using one of the ¼ threads.

Camera Exposure and the 60/40 Glass

After setting up the camera with the 60/40 glass in front of the lens adjust the camera set up and white balance. This is because the 60/40 Glass affects the camera exposure by approximately 1 stop almost like the effect of a neutral density filter. Consult your camera manual for further help and advice with its exposure and white balance settings.

TLM-700 Monitor Setup

To use the TLM-700 with the TTL-100 we must enable the monitors flip function, this will ensure the images from the HDMI source are correctly displayed via the mirror glass:

1. Press the ‘Menu’ button to open the on-screen display
2. Navigate to the bottom menu section with the cog icon by pressing the > button
3. Press the ‘Menu’ button to select this option
4. Navigate to the ‘Image Flip’ option
5. Press ‘Menu’ to select this option
6. Press > to set the flip function to ‘V’ (vertical flip)
7. Use the ‘Exit’ button to close the on-screen display

You may also want to disable the Histogram feature to remove the on-screen histogram:

1. Press the ‘Menu’ button to open the on-screen display
2. Navigate to the fourth menu section with the graph icon by pressing the > button
3. Press the ‘Menu’ button to select this option
4. Navigate to the ‘Histogram option
5. Press ‘Menu’ to select this option
6. Press > to set the function to ‘Off’
7. Use the ‘Exit’ button to close the on-screen display

Please consult the TLM-700 user manual for more information.

Cleaning the 60/40 Glass

This product contains a sheet of 60/40 glass please handle it with care. To avoid a risk of damage or injury please follow this instruction manual and use caution when transporting, unpacking, cleaning, assembling or disassembling this part of the product. Datavideo recommends cleaning the glass regularly to remove dust and finger print marks. This will ensure the best image quality is recorded when the camera is looking through the glass.  Never attempt to clean the glass whilst it is mounted instead remove it carefully, clean the glass, and then re-install it into the hood. Handle the glass carefully using the cloth-covered edges of the glass at all times. To retain the required qualities of the glass and to avoid scratching the glass during cleaning.

• Never use abrasive cloths, pads or abrasive-based cleaning fluids on the glass.
• Never use cleaning fluids based on an acid or vinegar solution.

Place the glass on a soft, stable, dirt and lint-free work surface such as a table with a clean cloth already laid out on it. Then use a second clean, lint-free, soft cloth to clean the glass. Do not apply cleaning fluids to the glass directly, instead apply or spray a small amount of the cleaning fluid onto the cloth. Proceed to clean the glass and work in a light circular motion with the cloth. Ensure all finger marks and streaks are gone before turning the glass over and repeating with the other side.

Once finished re-install the glass back into the hood, again using the cloth covered edges only. Ensure the green circle sticker on the glass is facing you and the red circle sticker is facing the camera lens. Reseat/secure the camera hood if necessary.

Specifications

Hood Size

• Width: 180 mm
• Height: 115 mm
• Depth: 105 mm

Hood Size (with monitor)

• Width: 125 mm
• Height: 134 mm
• Depth: 123 mm

Nett Weight:

• Kit: 280g
• With TLM-700: 650g

Packed weight: (Gross) Kit: 300g

Service & Support

It is our goal to make owning and using Datavideo products a satisfying experience. Our support staff is available to assist you to set up and operate your system. Contact your local office for specific support requests. Plus, please visit www.datavideo.com to access our FAQ section. Please visit our website for latest manual update. www.datavideo.com/product/TTL-100

All the trademarks are the properties of their respective owners. Datavideo Technologies Co., Ltd. All rights reserved 2020

References

• TTL-100 Through The Lens Kit for TLM-700 Series | Datavideo | Datavideo | Professional end-to-end solutions provider for your live video production.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>