L O C PRO ADVANCED LPA-2.4 LPH Harness Instruction Manual
- June 3, 2024
- L O C PRO ADVANCED
Table of Contents
L O C PRO ADVANCED LPA-2.4 LPH Harness
Wiring Connection Chart (All Models)
MODELS:
- LPA-E4
- LPA2.4 / LPA2.2
- LPA1.4 / LPA1.2
Important Note: This harness is provided with an inline fuse installed.
Please remove prior to installation and reinsert once finished. If your
vehicle does not provide an ACC source your harness will not have a
“RED” wire to connect.
It will use DC Offset to turn on as well as trigger the “REM OUT” on the LPA.
On LPA-E4 there will be a jumper that you can move based on your application.
This harness is designed to work on
OEM NON-AMPLIFIED systems.
Connect the RED BUTT Connector to the aftermarket system and turn it on for
your amplifiers.
Example Installation
4-Channel Amplifier – (HARNESS CUT REQUIRED)
- Cut the harness close as possible to the “CUT HERE AND INSULATE” label. You must insulate wires to prevent damage to the OEM radio.
- The cut speaker wires will need to be connected to your aftermarket amplifier. (REFER TO LABEL ON HARNESS)
- Please refer to the chart on the first page for wiring your loose wires to your LPA.
- This harness is designed to work on OEM NON-AMPLIFIED systems.
Example Installation – Mono Amplifier – (HARNESS CUT NOT REQUIRED)
- If using a 2-Channel input LPA use the front speaker wires and insulate the remaining rear speaker wires.
- DO NOT CUT the speaker wires between the “CUT HERE” labels in order to keep the factory speakers functional.
- This harness is designed to work on OEM NON-AMPLIFIED systems.
ANC vs Amplifier
- Amp is larger/Black
- ANC is small/Silver
- Amp has 3 plugs
- Actually black in the vehicle
- ANC has 2 plugs
ANC / Amp Location 2019+ RAM 1500
ANC / Amp Location 2019+ RAM 2500/3500
Under Driver Dash
ANC / Amp Location Jeep Cherokee
ANC / Amp Location Chrysler Pacifica
ANC Location 2015-2016 Grand Cherokee
Behind Right Quarter Trim Panel
