FABER P1211 Blender Fbg Blendy Instruction Manual

P1211 Blender Fbg Blendy
Instruction Manual

P1211 Blender Fbg Blendy

VOLTAGE : 220-240V FREQUENCY: 50-60Hz , 350W
PLEASE READ THIS INSTRUCTIONS MANUAL CAREFULLY BEFORE USING THIS PRODUCT

IMPORTANT SAFETY INSTRUCTIONS

When using this electrical appliance, basic safety precautions should always be followed, including the following :

1. Read all instructions.
2. Before using, check that the voltage indicated on the product corresponds with the voltage of your electrical outlet.
3. Do not let cord hang on hot surface or over edge of table or counter.
4. Do not operate any appliance with a damaged cord or plug or after the appliance malfunction or has been damaged in any manner. Return the appliance to the nearest authorized service facility for examination, repair or adjustment.
5. If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard.
6. Close supervision is necessary when any appliance is used by or near children.
7. Avoid contacting the moving parts.
8. Keep hands and utensils out of container while blending to reduce the risk of severe injury to persons or damage to the blender.
9. The use of attachments not recommended or sold by manufacturer may cause fire, electric shock or injury.
10. Unplug from outlet when not in use, before putting on or taking off parts, and before cleaning. To disconnect, turn any control to “0”, then remove plug from wall outlet by grasping the plug, not the cord.
11. To reduce the risk of injury, never place blade assembly on motor unit without the jar properly attached.
12. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliances by a person responsible for their safety.
13. Children should be supervised to ensure that they do not play with the appliance.
14. Do not leave the machine on unattended.
15. When removing the blender from the motor unit, wait until the blades have completely stopped.
16. Always operate blender with cover in place.
17. Always use the appliance on a secure, dry level surface.
18. Never place this appliance on or near a hot gas or an electric burner or where it could touch a heated appliance.
19. Do not use outdoors. 20. Do not use appliance for other than its intended use.

WARNING: Potential injury from misuse. Care shall be taken when handling the sharp cutting blades, emptying the bowl and during cleaning.
CAUTION: Ensure that the blender is switched off before removing it from the stand. Switch off the appliance and disconnect from supply before changing accessories or approaching parts that move in use.

TECHNICAL SPECIFICATIONS

THIS PRODUCT IS FOR HOUSEHOLD USE ONLY : –

PARTS : –

OPERATNG INSTRUCTION

HOW TO USE
Before initial use

1. Before first use, unpack the appliance and place all parts on a horizontal surface.
2. Assembling the jar assembly (including the measure cup, lid, seal ring, and jar base) into the motor unit. Disassemble to wash all detachable parts except the motor unit. Refer to the latter chapter CARE AND CLEANING.
3. Reassemble them after cleaning and drying thoroughly all parts

1. Re-position the jar assembly with its opening upwards. Wrap the seal ring around the lid bottom and put the lid onto the jar assembly. Place the measure cup exactly into the lid by fitting the small until tight (See Fig.3)
2. Finally, adjust the connector on the jar bottom well, and place the assembled jar assembly to the motor base with handle towards the direction of the unlocking sign, then tighten to the locking sign (See Fig.4/4A) .
3. Assembly the grinding cup components- Place the grinding cup seal ring into grinding cutter head components, and then buckle into the grinding cup. Please turn the cutter head components clockwise until tightly to ensure it assembly in place.(See Fig.S)
4. Place the grinding cup or chopper on the motor base and turn it anticlockwise until tightly to ensure it was assembled in place(See Fig.SA)

CAUSION: Do not try to twist the Jar and jar base onto the motor unit
HOW TO USE : –

1. Peeled or cored the fruit or vegetables and then cut them into small dices.
2. Place the food to be blended into the jar (See Fig.5) . Usually, certain amount of purified water has to be added to facilitate the smooth running of appliance. The proportion of the food and water is 2:3.The amount of mixture should not exceed the max level as indicated on the jar.
   INGREDIENT| REMARK| WEIGHT| SPEED
   ---|---|---|---
   Carrot/Apple| Cut Into 15mmel5mmel5mm|  480g & water  720g| High Speed

Note: never add boiling liquids into jar, or run the appliance empty.

3. Put the lid on the jar and be sure the measuring cup is in place.
4. Plug the power cord into a standard wall outlet.
5. Turn the speed knob to the appropriate speed setting for your task.
6. For quick or delicate blending tasks, turn the speed knob to P position and hold for a few seconds and then release, the knob will reset to 0 position automatically. Operate several times until get the effect you want. If you want to add ingredients while the blender is working, just open the measuring cup and lid (See Fig.6) .
7. When the effect you desire is obtained, turn the knob to 0 position

IMPORTANT NOTE –

1. For each use, the consecutive operation time should not exceed 3 minutes, and at least 10 minutes rest time must be maintained between two continuous cycles. Please let the unit cool to room temperature before performing next operation cycle.
2. If you want to stop the machine during operation, just turn the knob to 0 position anytime
   

IMPORTANT OPERATING TIPS:-

1. For best circulation of food that is to be blended with some liquid. pouring the liquid into the jar first, then add solid food.
2. Some of the tasks that cannot be performed efficiently with a blender are: beating egg whites, whipping cream, mashing potatoes, grinding meat, mixing dough, extracting juice from fruit and Vegetables, etc.
3. The following items should never be placed in the unit as they may cause damage: bones, large pieces of hard things, frozen food, or tough foods.

THE USING OF GRINDING CUP :-

1. Rotate open the grinding cup from grinding cutter head components and place on the table with open side up
2. Put bean food into grinding cup (About 50 grams) and turn-lock clasp well the grinding cutter head components, then lock it on the motor unit
3. Plug the power cord into a standard wall outlet; 4. Turn the speed knob to the second speed for your task.(generally need about 30 seconds) When achieved the effect you want, turn the knob to 0 position.

CARE & CLEANING
This product contains no user serviceable parts. Refer service to qualified service personnel.

1. Before cleaning, unplug the blender.
2. For easier cleaning, please always wash immediately after using. Don’t let food dry on the jar assembly as this will make cleaning difficult.
3. Pour a little warm soapy water Into the Jar and turn the knob to P position for a few seconds. And then empty the jar.
4. Rinse the measure cup, lid, seal ring and blade assembly by hands or in a dishwasher and then dry them. They are dishwasher safe components, but the temperature setting shall not exceed 7021.
5. Brush the blade clean with warm soapy water, then rinse thoroughly under the tap water. Don’t touch the sharp blades, handle carefully. Don’t immerse the blade assembly into water. Please inversion to dry and put in the place where children can’t touch.
6. Wipe the motor unit surface with a damp cloth and dry thoroughly. Remove the stubborn spots by rubbing with non-abrasive cleaner. If liquids spill into the motor unit, please unplug the unit first, then wipe with a dry cloth and dry thoroughly.

CAUSION :

1. Do not immerse the motor unit into liquids to prevent the risk of electric shock.
2. Do not use rough scouring pads or cleansers to clean the product.
3. Do not place engine base into dishwasher for cleaning. This unit is not available for dishwasher.

Dibuat untuk dan diedarkan oleh :
FIMACO SDN BHD
8-2, WISMA FIAMMA,
No.20, Jalan 7A/62A,
Bandar Manjalara, 52200 Kuala Lumpur, Malaysia.
CUSTOMER CARE CENTRE : +603 6279 8888

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>