Hunter 19690 4 Light Flush Mount Instruction Manual
- June 3, 2024
- Hunter
Table of Contents
19690 4 Light Flush Mount
Instruction Manual
For Models:
19690 19691
19690 4 Light Flush Mount
Light Flush Mount 4
Fixture weight +- ibs:
Here are the tools you’ll need to complete your installation:
| Here are the tools you’ll need to complete your installation: | Ladder |
|---|---|
| Screwdriver | Pliers |
INSTALLATION INSTRUCTIONS
WARNING
- To avoid possible electrical shock, before installing your light fixture, disconnect the power by turning off the circuit breakers to the outlet box associated with the wall switch location.
- The lighting fixture must be grounded. If the ground wire for the installation site is not present, immediately STOP installation and consult a qualified electrician.
- All wiring must be in accordance with national and local electrical codes ANSI/NFPA 70. If you are unfamiliar with wiring or in doubt, consult a qualified electrician.
READ AND SAVE THESE INSTRUCTIONS
These instructions are provided for your safety. It is very important that
they are read carefully and completely before beginning installation of the
lighting fixture.
PREPARING FOR INSTALLATION
Carefully remove all contents from the carton. Shut off the power at the
circuit breaker and completely remove the old fixture from the ceiling,
including the old mounting bracket. Remove screws (E) from canopy (D). Pull
the house wires through the center of mounting plate (A). Place the mounting
plate (A) on the junction box and tighten the screws (B) to secure the
mounting plate (A) to the junction box. 
CONNECTING THE WIRES
Have a helper support the fixture’s weight while completing the wiring. Attach
the fixture’s wires to the power supply wires from the junction box. Connect
black to black (live); white to white (neutral); grounding to grounding (green
or copper). Twist the ends of the wire pairs together. Then, twist on a wire
connector. Make sure all twists are in the same direction. Loop fixture’s
ground wire around grounding screw (C) and tighten. If there is no ground wire
(green or copper) from the junction box, contact a qualified electrician.
FINISHING THE INSTALLATION
Attach the fixture body (D) to the mounting plate (A) and secure it with the
supplied mounting screws (E). Raise the glass (G) to the fixture passing the
plate (H) over the sockets so that the threaded posts (F) protrude through the
holes in the plate. Secure with the cap nuts (I) on the threaded posts (F).
Install light bulb (not included) in accordance with the fixture’s
specifications. Do not exceed the recommended wattage. Turn on the power and
test the fixture. Your installation is now complete.
CLEANING TIPS
Treat the fixture gently! Regular cleaning will reduce the need for deep
cleaning. For regular cleaning, turn off the light and wipe down the fixture
with a clean lint-free cotton or microfiber cloth. Never spray cleaner
directly onto the fixture.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>