ROXTONE LX3F Low Profile Rotatable XLR Female Installation Guide

Table of Contents

$ROXTONE-LX3F-Low-Profile-Rotatable-XLR-Female-fig- $1$$

STEP 1 Remove about 15mm of the cable jacket.
STEP 2 Fray and twist the shielding tight. Remove about 4mm of the lead jacket at the end.
STEP 3 Put the heat-shrink tube over the shielding, leaving the 4mm tip exposed.
STEP 4 Solder the leads into the insert solder cups, heat the shrink tube. Install the mini-zip tie 4mm from jacket section and tighten, cut the excess part.
STEP 5 Depending on different application scenarios, the product can be divided into two assembly modes A and B (as shown in the following figure) according to the orientation of the cable exit. $ROXTONE-LX3F-Low-Profile-Rotatable-XLR-Female-fig- $6$$ $ROXTONE-LX3F-Low-Profile-Rotatable-XLR-Female-fig- $7$$ $ROXTONE-LX3F-Low-Profile-Rotatable-XLR-Female-fig- $8$$ $ROXTONE-LX3F-Low-Profile-Rotatable-XLR-Female-fig- $9$$ $ROXTONE-LX3F-Low-Profile-Rotatable-XLR-Female-fig- $10$$ $ROXTONE-LX3F-Low-Profile-Rotatable-XLR-Female-fig- $11$$
STEP 6 Depending on your usage needs, as shown below, the back cover can be turned within 100° in the same direction to align the cable exit to your preferred position.

STEP 1 Remove the color ring. $ROXTONE-LX3F-Low-Profile-Rotatable-XLR-Female-fig- $14$$
STEP 2 Remove the shell. $ROXTONE-LX3F-Low-Profile-Rotatable-XLR-Female-fig- $15$$ $ROXTONE-LX3F-Low-Profile-Rotatable-XLR-Female-fig- $16$$

Item Code:

$ROXTONE-LX3F-Low-Profile-Rotatable-XLR-Female-fig- $17$$

STEP 1 Remove about 15mm of the cable jacket.
STEP 2 Fray and twist the shielding tight. Remove about 4mm of the lead jacket at the end.
STEP 3 Put the heat-shrink tube over the shielding, leaving the 4mm tip exposed.
STEP 4 Solder the leads into the insert solder cups and heat the shrink tube. Install the mini-zip tie 4mm from the jacket section and tighten, and cut the excess part. $ROXTONE-LX3F-Low-Profile-Rotatable-XLR-Female-fig- $21$$
STEP 5 Depending on different application scenarios, the product can be divided into two assembly modes A and B (as shown in the following figure) according to the orientation of the cable exit. $ROXTONE-LX3F-Low-Profile-Rotatable-XLR-Female-fig- $22$$ $ROXTONE-LX3F-Low-Profile-Rotatable-XLR-Female-fig- $23$$ $ROXTONE-LX3F-Low-Profile-Rotatable-XLR-Female-fig- $24$$ $ROXTONE-LX3F-Low-Profile-Rotatable-XLR-Female-fig- $26$$ $ROXTONE-LX3F-Low-Profile-Rotatable-XLR-Female-fig- $27$$
STEP 6 Depending on your usage needs, as shown below, the back cover can be turned within 100° in the same direction to align the cable exit to your preferred position.