FABER BACK Series BACKSPLASH Kit Instruction Manual
- June 3, 2024
- FABER
Table of Contents
FABER BACK Series BACKSPLASH Kit Instruction
PARTS
- Backsplash
- Pozi Screws (Screws 3/16″ x 1-15/16″)
- Wall plug (3/16″ x 2-3/4″)
DIMENSION
INSTALLATION
WARNING! The backsplash should be installed before the hood is installed.
- Position the lower section of backsplash on the wall. Center it side to side and markthe mounting holes. Remove the lower section from the wall.
- Attach the lower section of the backsplash to the wall with the 6 screws (G) provided.
- Position the upper section of the backsplash on the wall. The top position of the upper section should be at least 1” above the bottom of the hood so the recessed screws are covered. Center it side to side and mark the holes. Remove the upper section from the wall.
- Peel off the double-sided tape. Attach the upper section to the wall with 3 screws (G) provided.
- Press the upper section to the lower section to make sure the tape fully adheres tothe lower section.
CLEANING STAINLESS STEEL
Cleaning Exterior surfaces
Please note, abrasives and scouring agents can scratch range hood finishes and
should not be used to clean finished surfaces.
Stainless Steel finish cleaning instructions
Clean exterior surfaces with a commercially available stainless steel cleaner.
991.0682.077_01 – 220524 D000000008732_00
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>