WILTRONICS GT4285 1:16 Scale R/C Rock Crawler with Drift Wheels User Manual

WILTRONICS GT4285 1:16 Scale R/C Rock Crawler with Drift Wheels

Instructions

• The non-rechargeable battery is not to be recharged.
• Only batteries of the same or equivalent type as recommended are to be used.
• Batteries are to be inserted with the correct polarity.
• Exhausted batteries are to be removed from the toy.
• The supply terminals are not to be short-circuited.
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc), or rechargeable (nickel-cadmium) batteries.
• Please take out batteries when not in use.
• Keep this package for reference since it contains important information.

Control Methods

Battery charging and assembly

1. USB charging cable charging method.
   Insert the USB cable into the interface of a computer or the USB interface of a mobile phone charger, then connect the USB cable with the battery pack as shown in the picture, and the red USB indicator light will turn on, indicating that it is charging. Approximately 120 minutes later, the red indicator light will be off and charging is completed.

2. Use a screwdriver to turn the screw on the battery cover at the bottom of the RC car counterclockwise, open the battery cover, assemble the battery into the battery slot with the correct electrode, cover the battery cover, and tighten the screw. (As shown in pictures)

3. Remote controller battery installation method (As shown in the picture):

4. Remove the battery lid;

5. Load two 1.5V AA alkaline batteries and check whether the electrodes of the batteries are proper.

6. Replace the lid as shown.

Distributed by:
Electus Distribution Pty Ltd
46 Eastern Creek Dr,
Eastern Creek NSW 2766 Australia Ph 1300 738 555
Int’l +61 2 8832 3200
Fax 1300 738 500
www.electusdistribution.com.au.

References

• Electus Distribution - Home

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>