WILTRONICS GT4282 Wireless Retro Arcade Game Console User Manual
- June 3, 2024
- WILTRONICS
Table of Contents
2 CONTROLLER
WIRELESS RETRO ARCADE
GAME CONSOLE
WITH 638 GAMES
USER MANUAL
Box Contents
1 x Wireless HDMI Dongle
2 x Wireless Controllers
1 x USB Power Cable
Product Diagram
Operation
- Plug the wireless HDMI dongle in to the HDMI port of your TV or monitor.
- Plug the USB micro B plug of the power cable to the power socket of the wireless HDMI dongle.
- Plug the opposite end of the USB power cable to the USB port of your TV or a USB mains power adaptor (Not Included).
- The LED indicator of the wireless HDMI dongle will light up once powered.
- Remove the battery cover from the wireless controller and install 2 x AAA(Not Included) batteries using the correct polarity.
- Place the battery cover back over the wireless controller and press the power switch to On, repeat steps 5-6 for the second wireless controller.
Functions
Page Up: Press the right direction button to go to the next page of
games.
Page Down: Press the left direction button to go to the previous page of
games.
Return Home: Press and hold the START & SELECT buttons for up to 2
seconds.
Standby Mode: The unit will automatically enter standby mode after 7
minutes of no use, press the START button to reconnect the device.
Troubleshooting
The game console won’t start.
– Check to see that the wireless HDMI dongle is powered correctly, it requires
a 5VDC, 500mA USB port
so your TV may not support this. Try a USB mains power adaptor of at least
500mA charging.
The game console is frozen.
– The controller battery is too low; check and replace the batteries in the
controllers.
– Disconnect and reconnect the USB power cable of the wireless HDMI dongle to
restart the device.
Safety
- Do not open the case of the wireless HDMI dongle or controllers to avoid damage and injury.
- Keep the wireless HDMI dongle or controllers away from high temperatures as it may cause damage to the battery.
- Do not expose the wireless HDMI dongle or controllers to water, moisture or liquids to prevent the unit from damage.
Specifications
Frequency: 2.4GHz
Resolution: Up to 1080i
Play Time: Up to 6 Hours
Battery: 2 x AAA Each Controller (Not Included)
Power: 5VDC, 500mA (Micro B USB)
Dimensions:
88(L) x 34(W) x 10(D)mm (Wireless Dongle)
143(L) x 68(W) x 28(D)mm (Controller)
Distributed by:
Electus Distribution Pty Ltd
46 Eastern Creek Dr,
Eastern Creek NSW 2766 Australia
Ph 1300 738 555
Int’l +61 2 8832 3200
Fax 1300 738 500
www.electusdistribution.com.au
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>