VIOTEK viot00571 Accelerometer Node User Guide
- June 3, 2024
- Viotek
Table of Contents
viot00571 Accelerometer Node
User Guide
MOUNT
Mount the device firmly to your chosen location using a secure mounting method: Twosided adhesive, side mounting holes and/or pole mount bracket for threaded holes.
USING THE MAGNET
Wherever instructed to tap the node using the magnet, do so at the spot
indicated “X”.
Sequential taps must be performed within 3 seconds before the device count
resets.
CONFIRM STATUS
Tap Once
- If the device is off, a solid blue light will appear from the status LED. Proceed to step 4.
- If the device is on, a solid green light followed by a red light will appear from the status LED. Proceed to step 6.
TOGGLE DEVICE ON
Tap Twice
- This will turn the device on. Accelerometers use substantial power, please proceed to step 5 when device is not in use.
TOGGLE DEVICE OFF
Tap Twice
- This will turn the device off followed by a solid blue LED.
STATUS
GREEN| On
BLUE| Off
RED| Device is busy
COMMS
BLUE| Communicating with server
YELLOW| Collecting GPS Coordinates
RED| Unable to Communicate
OUR RESONANCE
Resonance describes the phenomenon of increased amplitude that occurs when aan
external force or a vibrating system is equal or close to a natural frequency
of the system on which it acts.
Leveraging decades of experience in earthquake analysis and monitoring of
mining seismicity, Viotel have a deep understanding of resonance and have
developed a unique series of asset management solutions involving monitoring
and analysis of vibrations and waveforms.
The Viotel Wireless Accelerometer Node is an ultra-low noise triaxial MEMS
sensor and self-contained with a digital communication interface.
It comes pre-programmed and ready to mount in the desired location and is
suitable to measure the vibration modes in buildings.
https://www.viotel.co/accelerometer.html
Please refer to the User Manual for more information and a full guide on this
device.
For queries, email support@viotel.co