CREM EX3 Wooden and Aluminium Cover Kit Instruction Manual
- June 3, 2024
- CREM
Table of Contents
CREM EX3 Wooden and Aluminium Cover Kit Instruction Manual
Installations Instruction
-
Take the parts out of the box.
-
Prepare a spacious and clean area to work. Screwdriver Philips will be needed.
-
Cup tray fence: Pull up the cup tray fence (A). Once you have pulled it up, set it aside.
-
Machine side panels: Loose the four screws marked (B). Side panels should be removed easily.
-
Top panel: Loose the two screws marked (C). Push the panel in the arrow direction (C) (horizontally, and then, upwards).
-
Rear panel: Turn 90º degrees the metal flexible tab marked (D). Repeat for both sides.
-
Loose the two screws marked (E). Rear panel should be removed easily.
-
Clean contact surfaces of the machine removed panels with alcohol. (F)
- pro tip: once you have cleaned the panels, heat them with a hair dryer or heat gun.
-
Place the cover panels in the correct position. Ensure that the parts are aligned on the top. (G)
-
Make pressure on the cover panels for 30 minutes. Be careful not to scratch them. (H)
-
Assembly the panels (reverse steps from 7 to 3). (I)