AUTEL MaxiSys MS906 Pro Diagnostic Tools User Guide

: June 3, 2024
: AUTEL

Table of Contents

AUTEL MaxiSys MS906 Pro Diagnostic Tools
VCI LED Description
Read User Manual Online (PDF format)
Download This Manual (PDF format)

AUTEL MaxiSys MS906 Pro Diagnostic Tools

Thank you for purchasing this Autel MaxiSys MS906 Pro. Our tools are manufactured to a high standard and – when used according to these instructions and properly maintained – will provide years of trouble-free performance.

@ MaxiSys MS906 Pro Display Tablet

8-inch LED Capacitive Touchscreen
Ambient Light Sensor – detects ambient brightness
Power LED
Front Camera
Microphone
Collapsible Stand – extends from the back to allow hands-free viewing of the tablet
Rear Camera
Camera Flash
TF Card Slot
DC Power Supply Input Port
Mini USB Port
USB Port (for VCI Connection)
HDMI Port
Headset Jack (3-band 3.5mm)
Lock/Power Button – press and hold to turn on/off the tablet, or tap to lock the screen

@ VCI (Vehicle Communication Interface) Device – MaxiVCI V200

Flashlight Power Button
Power LED
Vehicle/Connection LED
Vehicle Data Connector (16-pin)
USB Port

VCI LED Description

LED	Color	Description

Power LED

| Yellow| The VCI is powered on and performing self-check.
Green| The VCI is ready for use.
Flashing Red| The firmware is updating.

Vehicle

/Connection LED

| ****

Green

| • Solid Green: The VCI is connected via USB cable.

• Flashing Green: The VCI is communicating via USB cable.

Blue

| • Solid Blue: The VCI is connected via Bluetooth.

• Flashing Blue: The VCI is communicating via Bluetooth.

IMPORTANT: Before operating or maintaining this unit, please read these instructions carefully, paying extra attention to the safety warningsand precautions. Failure to use this product properly may cause damage and/or personal injury and will void the product warranty.

Insert the Vehicle Data Connector on the MaxiVCI V200 into the vehicle’s DLC, which is generally located under the vehicle dashboard.
Ensure the tablet is sufficiently charged or is connected to the supplied DC power supply.
Power up the tablet.
Pair the tablet with the MaxiVCI V200 via Bluetooth to establish a communication link.

NOTE : The tablet and the MaxiVCI V200 are configured to auto matically synchronize with each other on first use, so there should be no need to pair up.

Alternatively, connect the tablet and the MaxiVCI V200 using the USB cable . AUTEL-MaxiSys-MS906-Pro-Diagnostic-Tools-FIG-7

When the MaxiVCI V200 is properly connected to the vehicle and the tablet, the VCI status button on the bottom bar of the screen will display a green badge with a check mark at the corner indicating the tablet is ready to start vehicle diagnosis.