Aqua Illumination HMSSA Single Arm Mounting Kit Installation Guide

Aqua Illumination HMSSA Single Arm Mounting Kit

WARNING
Failure to read or follow the directions below may result in damage to the HMS kit, a broken light, and/or damage to your tank, livestock, and nearby areas. Any damage resulting from failing to read or follow the directions will not be covered under warranty and C2 Development, Inc. will not be liable for any resulting damage.

For video tutorials about this installation and others, visit: support.aquaillumination.com

What’s Included

• Step 1
  • Hold the mounting rail over the aquarium.
  • Use a pencil to mark the center point light placement.
  • Use a pencil to mark where the edge of the aquarium line up with the mounting rail. (this will be used for vertical rail placement.)
• Step 2
  • Place the mounting rail and vertical rail next to each other so that the center channel is accessible.
  • Run the light power cable through the channels on both bars (see image above).
• Step 3
  • Pull the power supply cable out of the center channel and locate it at the light placement mark closest to the vertical rail.
  • Slide on the Hydra FiftyTwo/Hydra TwentySix bracket to the same light placement mark and tighten screw.

• Step 4
  Insert the mounting rail and vertical rail into the pivoting bracket as shown above. Make sure that the bracket is oriented to the mounting rail.

• Step 5
  With the vertical rail attached relocate the mounting rail to line up with the tank edge mark.

• Step 6

  • Tighten bracket attachment screws A & B.
  • Adjust Mounting Rail tension with C.

• Step 7

  • Make sure the nut and bolt are loosely screwed together on the clamp to allow the nut to fit into the rail side channel.
  • Slide the clamp onto the vertical rail as shown above.

• Step 8

  • Slide the clamp to the position that will reflect the desired height of the HMS to be mounted above the aquarium.
  • Use the included Hex key and tighten the screw on either side of the clamp to secure in place.

• Step 9
  If necessary, before mounting the light, make fine adjustments to HMS assembly width with respect to tank edges.

• Step 10
  Off of the tank, attach your Hydra to the Hydra FiftyTwo/Hydra TwentySix bracket and plug it into the previously routed cable.

• Step 11
  Attach the two End Caps to each side of the Mounting Rail.

• Step 12
  Place the HMS assembly on top of the tank and tighten clamp thumbscrew to make sure it is tight enough to stay secure to the glass.

• Step 13
  Create a drip loop before the extension connector by ensuring your power cable has enough length to droop down below the connector, then back up.

Warranty

C2 Development, Inc. shall warrant the Hydra Mounting System (HMS™) and parts for 30 days from the date of purchase against manufacturing defects and workmanship only. This warranty is non-transferable and valid for the original purchaser only. For contact information please see: http://www.aquaillumination.com/support/warranty.html

Disclaimers

Use only materials supplied or approved by C2 Development, Inc. Failure to follow these instructions will void the HMS warranty, any applicable light warranty, and C2 Development, Inc. will not be liable for any and all damage resulting from failure to follow the instructions.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>