LOGIC A5L 4G Bar Phone User Guide
- June 3, 2024
- Logic
Table of Contents
A5L
4G BAR PHONE
QUICK GUIDE
A5L 4G Bar Phone
Thank you for purchasing this innovative Logic device. The specifications in
this document are subject to change without prior notice.
Logic and the Logic logo are registered trademarks of Swagtek. Inc. Other
trademarks are property of their respective owners.
Charge for 24 hours before using.
Install SIM card /memory card.
Get to know your Logic phone.
Connect your Logic phone to a computer with a USB Cable (cable not included).
Copy music files from your computer to your Logic phone.
FCC Statement
-
This device complies with Part IS of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received. including interference that may cause undesired operation. -
Changes or mod cations not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment
NOTE This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy ond, if not installed and used in accordance with the instructions. may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and co,. the user is encouraged to try to correct the interference by one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help.
SAR Information Statement
Your wireless phone is a radio transmitter and receiver. It is designed and
manufactured not to exceed the emission limits for exposure to radiofrequency
(RF) energy set by the Federal Communications Commission of the U.S.
Government These limits ore part of comprehensive guidelines and establish
permitted levels of RF energy for the general population. The guidelines are
based on standards that were developed by independent scientific organizations
through periodic and thorough evaluation of scientific studies. The standards
include a substantial safety margin designed to assure the safety of all
persons, regardless of age and health. The exposure standard for wireless
mobile phones employs a unit of measurement known as the Specific Absorption
Rate. or SAR. The SAR limit set by the FCC is 16 W/kg. ‘ Tests for SAR are
conducted with the phone transmitting of its highest certified power level in
all tested frequency bands. Although the SAR is determined of the highest
certified power level, the actual SAR level of the phone while operating can
be well below the maximum value. This is because the phone is designed to
operate at multiple power levels so as to use only the power required to reach
the network In general, the closer you are to a wireless base station antenna.
the lower the power output. Before a phone model is available for sale to the
public. it must be tested and certified to the FCC that it does not exceed the
limit established by the government adopted requirement for safe exposure. The
tests are performed in positions and locations (e.g. of the ear and worn on
the body) as required by the FCC for each model. The highest SAR value for
this model phone when tested for use at the ear is 0.396W/Kg and when wom on
the body. as described in this user guide. is 0.472W/Kg(Body-worn measurements
differ among phone models, depending upon avdlable accessories and FCC
requirements). The maximum scaled SAR in hotspot mode is 0.498W/Kg. While
there may be differences between the SAR levels of various phones and at
various positions. they all meet the government requirement for safe exposure.
The FCC has granted an Equipment Authorization for this model phone with all
reported SAR levels evaluated as in compliance with the FCC RFexposure
guidelines. SAR information on this model phone is on file with the FCC and
can be found under the Display Grant section of http://www.fcc.gov/
oet,/fccid after searching on FCC ID: 055183722 Additional information on
Specific Absorption Rates (SAR) can be found on the Cellular
Telecommunications Industry Asso-ciation (CTLA) web-site at http://www.wow-
com.com.
• In the United States and Canada, the SAR limit for mobile phones used by the
public is 16 watts/kg (W/kg) averaged over one gram of tissue. The standard
incorporates a sub-stantial margin of safety to give additional protection for
the public and to amount for any variations in measurements.
Body-worn Operation This device was tested for typical body-wom operations. To
comply with RF exposure requirements, a minimum separation distance of 10mm
must be maintained between the user’s body and the handset including the
antenna. Third-party belt-clips. holsters. and similar accessories used by
this device shout.’ not contain any metallic component& Body-wom accessories
that do not meet these requirements may not comply with RF exposure
requirements and should be avoided. Use only the supplied or on approved
antenna
Body-worn Operation
This device was tested for typical body-worn operations. To comply with RF
exposure requirements, a minimum separation distance of 10mm must be
maintained between the user’s body and the handset, including the antenna.
Third-party belt-clips, holsters, and similar accessories used by this device
should not contain any metallic components. Body-worn accessories that do not
meet these requirements may not comply with RF exposure requirements and
should be avoided. Use only the supplied or an approved antenna.
Warranty Certificate
Terms and Conditions
LOGIC warrants that their Products will be free from defects in material and
workmanship. The warranty period is one (1) year for the products and three
(3) months for the accessories which are part of the original package
including the battery. The warranty period begins the date of purchase by the
End-User who shall present an invoice or a purchase receipt when requiring
warranty service otherwise the warranty period will begin from the date of
manufacture of the product. LOGIC will repair a product without cost to the
customer if it presents a manufacturing defect or defect in workmanship during
the warranty period and if the defect occurred under normal conditions of use
in accordance with the instructions and specifications stated in the user’s
manual. To download the user manual go to:
logicmobility.com
For additional information about the terms and conditions of LOGIC’s Limited
Warranty or to obtain warranty service information, please visit the support
section at: logicmobility.com
Iogicmobility.com
Made in China
Copyright Swagtek, Inc. 2022
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>