Lorelli TANGO Electric Swing Instruction Manual

Pleasant Relex
electric swing
TANGO
age range: 0+ months Instruction Manual

TANGO Electric Swing

Scan the QR code to get more product information and manual instruction in more languages. Download QR Scanner App onto your device.

IMPORTANT! READ CAREFULLY AND KEEP FOR FUTURE REFERENCE!

SAFETY REQUIREMENTS

1. WARNING! This product is suitable for use by babies ranging from 0 to 6 months old with a maximal weight of 9 kg.
2. WARNING! Never leave the child unattended.
3. WARNING! Do not use this product once your child can sit up unaided or weighs more than 9 kg.
4. WARNING! This product is not intended for prolonged periods of sleeping.
5. WARNING! Never use this product on an elevated surface (e.g. a table).
6. WARNING! Always use the restraint system.
7. WARNING! To avoid injury ensure that children are kept away when unfolding and folding this product.
8. WARNING! Do not let children play with this product.
9. WARNING! Do not move or lift this product with the baby inside it.
10. WARNING! When the product is connected to a music player, ensure that the volume of the music player is set to a low value.
11. When using the product as a swing: WARNING ! Do not move or lift this product with the baby inside it!
12. WARNING! The rocking chair shall be grounded in places with a slope not more than 3 degrees!
13. WARNING! Toy bar is an additional article! Keep removed toy bar on a safety place! Never use the toy bar to carry the product!
14. WARNING! Never use on a soft surface (bed, sofa, cushion) since the product can tip over and cause suffocation in soft surfaces.
15. WARNING! This article does not replace a cot or a bed. Should your child need to sleep, then it should be placed in a suitable cot or bed.
16. WARNING! For domestic use only I
17. WARNING! Regularly check for loose parts! Make routine inspection, regularly maintain, clean and/or wash the article!
18. WARNING! Do not use this product if any components are broken or missing I
19. WARNING !Images on the title page and in the instruction manual are only illustrative and may differ from the real product,

CAUTION: This package contains small parts in its unassembled state!

• On adjusting the backrest you must be sure that the mechanism is well locked in the chosen position.
• Use the upright position only when child has developed enough upper body control to sit without leaning forward.
• Do not leave the article near a switched on fan, heat sources, sharp objects and water containers
• Do not use accessories or replacement parts other than those approved by the manufacturer.
• Adult assembly is required.
• Product features and decorations may vary from photographs.
  EN 16232:2013 +A1:2018 , EN 12790:2009, EN 62115, EN 71

PARTS

Picture 1

1. Vertical bases – 2pcs. left and right .
2. Feet tube – 2pcs.
3. Seat lifting arm tubes – 2pcs. left and right
4. Seat – 16p.
5. Fixed sets -16p.
6. Front support tubes of the seat – 1pcs 10.
7. Rear support tubes of the seat – 1pcs.
8. Dinner plate – 1pcs.
9.  Toy bar – 1pcs..
10. Adapter – 1pcs.
11. Remote control -1 pos

ASSEMBLING

WARNING I It should be Installed by adult.

1. Open the supporting arm of the vertical bases as shown in Picture 2
2. Insert the vertical bases into the feet tube until you hear a click. Picture 3
3. lace the seat suspension tubes on the axes of the vertical bases. Picture 4.1. Place the fasteners in the sequence 2; 3; 4.
4. Connect the front and rear seat support tubes to the B-B holes until you hear a click. Picture 5
5. Attach the seat attachment to the C-C slots Picture 6.
6. Insert the two end “D” on the front support tubes into the “D” holes in the seat base. Picture 7
7. Place the seat on the hooks of the E-E suspension hoses and make sure the locking pin is aligned with the base of the seat on both sides. Picture 8
8. Install the dinner plate on the seat group in the direction of the arrow. Picture 9.
9. nstall the toy bar as is shown on Picture 10.

SET UP AND USE

1. Description of the control panel. Picture 11
   1.1. Turn on (Turnoff) the device from button (1).
   1.2. Swing. There are five levels to adjust the swing speed divided by (3) and (4) buttons. Above the buttons is the light indication (2) for the selected speed.
   1.3. Timer . There are three types of time setting 8;15 and30 minutes. Press buton (5) once and light (7) will be turn on for 8 minutes. Press it second time, the light will be turn on for 15 minutes. Press it third time, the light will be switched on for 30 minutes. When setting time is reached, all functions will stop. If time setting function is not used, all using function will start working until power is off from button (1).
   1.4. Music button. (8). Press the button to play the music.Next pressing will stop the music. From the control button (8), you can adjust the volume and change the tracks These two functions are divided by the remote control – adjusting the sound with buttons (8) and changing the tracks with buttons (10). Position (9) Infra red diode.
   1.5. MP3 Function – Insert USB flash device into the USB port on the bottom side of the control panel. After few seconds the music will start playing automatically. Play and pause the music with pressing of button (6) . Short pressing of button (8) will change to next song. Hold button (8) to adjust the sound volume.

2. Adapter (1) Picture 12 – Insert DC plug (2) of adapter to DC receiver of chair (3) . Insert the AC plug (1) into 100-240V 50/60Hz 0.2AAC socket.
   WARNING III For your own safety, please, use only the original power adapter. Input voltage AC 100 – 240 V 50-60Hz 0.2A Max / Output voltage : = DC 5.8 V 800 mA (The manufacturer shall not be liable for any losses incurred due to use of power adapters other than the one specified. ) Do not use damaged power adapters. Do not touch the plug of the power adapter with conductive materials, for example rings. Do not let the child to play with the adapter or with the batteries! Keep the adapter out of the reach of children when plugged in and has power ! Transformers used with the infant swing are to be regularly examined for damage to the cord, plug, enclosure and other parts, and in the event of such damages, they shall not be used. The infant swing shall only be used with the recommended transformer.

3. Batteries . When using battery power, disconnect the AC adapter from the mains and unplug it from the power socket of the product. WARNING! Otherwise, the product can not be used with battery power! This product use 4pcs. of batteries type AA 1,5 V. Loosen the screws on the battery cover with a screwdriver. Open the cover. Picture 13. The battery should be placed in the battery slot with correct polarity,”+” and ” – “

CHANGE BATTERY

• Loosen the screws on the battery cover with a screwdriver. Open the cover.
• Place 4 pcs. 1,5 V type AA alkaline batteries (not included) as indicated in the inside of the battery compartment. Tip: It is recommended the use of alkaline batteries for extended operation.
• Reinstall the battery cover and tighten the screws with a screwdriver. Do not tighten excessively.
• If the product starts with malfunction, it may be necessary to reset the electronics. Remove batteries and then insert them again.
• When the sound begins to weaken or stop, it’s time to change the battery by an adult! Unscrew the bolt and open the battery compartment cover of the soothing unit located under the seat. Insert 1 pcs. battery type “D” 1.5 V in accordance with the polarity “+” and “
• shown in the compartment. Picture 14; 16 – Replace the battery cover and tighten the screws with a screwdriver. Do not over-tighten. To replace the remote control battery, press the button on the bottom and pull out the battery. Picture 15 Put 1 pc. Battery type CR2025 3V by following the polarity “+” and “-” on the back of the remote

Protect the environment by not disposing of this product with household waste (2012/19/EC). Check the recommendations to local authorities about recycling (Only for Europe).

BATTERIES SAFETY INFORMATION

WARNING! In some special condition fromthe battery may leak the liquid, which may cause a chemical bum or damage the product. to avoid battery s leakage:

• Do not mix old and new batteries or different types of batteries like alkaline, standard (carbon-zinc ) or rechargeable batteries (Ni-Cr)

• Please insert the batteries as indicated inside of the battery compartment.

• If you don’t use this product for a long time, please remove the batteries. Exhausted batteries are to be removed from the infant swing. Please carefully dispose the waste batteries. Do not dispose the batteries in to the fire. The battery may explode or leak.

• Do not cause short circuit of the batteries terminal.

• Use only the same batteries or batteries from one type as is required .

• Do not recharge non rechargeable batteries .

• Take out the batteries from the product before recharging.

• If you use rechargeable batteries, the charging should be under adult control.
  Soothing unit

• The soothing unit can be adjusted at 3 positions Picture 16. Slide the button from left to right to turn on and adjust the vibration level.
  Adjusting of the back rest. The backrest is adjustable in 3 positions. Picture

17. Raise the thumb (1), lift the handle (2) up and adjust the backrest

WARNING ! When adjusting the function, please let baby leave the chair first. Warning! Seat adjustment button must be bounced back, if you find any side of the seat is not fixed, loose or not work. Please fix it before use. Both sides of the seat must be fixed, otherwise there will be dangerous!
Rocking chair. Hold the seat on the base on both sides, release the locking buttons and lift up to release the rocking chair from the cradle. Photo 18 Warning: Use the rocking chair only on equal surfaces! Pull back the tube under the seat (Picture 19) to use the rocking chair as a stationary seat.
The toy base can be rotated to 90 ° for a more comfortable removal of the child. Picture 20. The roulette rotate 360 ° manually.
Folding. Stand on front of one foot and press the folding buttons on both sides simultaneously and fold. Repeat the procedure for the other foot. Picture 21. 9. Connect the belt with the buckle as shown in Picture 22.

SECURE YOUR CHILD

WARNING : Always use the restraint system I Picture 23 Place your child into the seat. Position the restraint pad between your child’s legs. Fasten the waist belts to each side of the restraint pad. Make sure you hear a “Clicknon both sides. Check to be sure the restraint system is securely attached by pulling it away from your child. The restraint system should remain attached. Tighten each waist belt so that the restraint system is snug against your child. Adjusting the length of the belts: Adjust the waist belts with pressing of the button and sliding of the buckle (Picture 24) and the shoulder belts with sliding of the buckle (Picture 25).

MAINTENANCE AND CARE

1. Wash the pad with cold water and soft soap. Dry naturally. Do not use bleach. Tumble dry separately on low heat and remove promptly.
2. The frame, toy bar and toys may be wiped clean using a mild cleaning solution and a damp cloth. Do not use harsh or abrasive cleaners. Rinse dean with water to remove residue. Do not immerse the frame or the toys.

STORAGE

1. Remove the batteries and store away from children.

Didis Ltd.
Bulgaria, Shumen, 6 Trakia-iztok Street
Phone: +359 54 850 830
e-mails: home.market@didis-ltd.com;
export@didis-ltd.com
Unic importator in Romania
DIDIS INTERNATIONAL
Strada Sfantul PanteLimon Nr.1
Oras PanteLimon, Judetul Ilfov
Phone: +40 21 211 65 60
Fax: +40 21 210 65 62
E-mail: office@didis.ro https://lorelli.eu/media/documents/products/Swings/TANGO_Manual%20Instruction_2019.pdf**www.lorelli.eu
find us on**

Documents / Resources

| Lorelli TANGO Electric Swing [pdf] Instruction Manual
TANGO Electric Swing, TANGO, TANGO Swing, Electric Swing, Swing
---|---

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>