SBOL Lamp Leg Instruction Manual
- June 6, 2024
- SBOL
Table of Contents
installation method:
- Remove everything from the box. Check you have the lamp with one leg attached via the wire.1 separate leg to be attached.1 tool bag.
- Slide the separate leg onto the connection on the lamp body as shown in Fig.1
- Tighten 2 screws in the holes on the leg well. Loose tightening may result in your lamp falling over or damage later on.
- Gently pull the cable tight and this will cause the attached leg to move into the connection on the lamp body.
- Tighten 2 screws in the holes on the leg as shown in Fig.3
Warning
- Do not use the power supply beyond the specified range (100-240V, 50Hz)
- Should avoid scratching the surface and wires of the lamp during installation
- Do not install the lamp outdoors.
- The lamp should not be close to corrosive chemical objects or gases. It should not be washed with water. It can only be wiped with a clean soft cloth.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>