ITC 69231B and 69240 LED Radiance Light Instruction Manual
- June 3, 2024
- ITC
Table of Contents
ITC 69231B and 69240 LED Radiance Light
Installation Instruction
PARTS/TOOLS NEEDED:
| |
| ****
Radiance Overhead Light| Wire Nuts (Not Provided)| Power Drill w/Hole Saw Bit (Not Provided)| Mounting Screws (Not Provided)
IMPORTANT SAFETY INSTRUCTIONS.
READ CAREFULLY FOR YOUR PROTECTION AND SAVE ALL INSTRUCTIONS.
- Disconnect power before installing, adding or changing any component.
- To avoid a hazard to children, account for all parts and destroy all packing materials.
- It is recommended that fuse protection be added to the positive (+) input.
-
Determine where your LED light fixture will be installed. Once dtermined, drill a hole using a hole saw (see chart below for hole size requirement).
-
Mounting Method : Cutout
* 69231B (81229) 2.25”
* 69240 (81232) 3.5”
* 69926 2.5”
-
Use the wiring diagram below to wire the light to the units power.
-
Installing the spring clip version: Push the clips on both sides of light up and slide housing and clips through hole. Clips will snap down and hold the light in place.
-
Installing the screw mount version: Remove cover by twisting counter clockwise. Mark location of screw holes and pre-drill. Screw in fixture and re-install cover by twisting clockwise
-
Installing the leaf spring version: Push light in at an angle and press down on opposite side until light is firmly seated in hole
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>