ITC 7003B-FF-KK Sheen Low Profile Light Instruction Manual
- June 3, 2024
- ITC
Table of Contents
Sheen™ Low Profile Light
Part#: 7003B-FF-KK
INSTALLATION INSTRUCTIONS
PARTS/TOOLS NEEDED:
| Sheen™ Low Profile Light | Two #8 Pan head screws (Not Provided) |
|---|---|
| Protective Grommet (Not Provided) | Power Drill |
IMPORTANT SAFETY INSTRUCTIONS. READ CAREFULLY FOR YOUR PROTECTION AND
SAVE ALL INSTRUCTIONS.
- Disconnect power before installing, adding or changing any component.
- To avoid a hazard to children, account for all parts and destroy all packing materials.
- It is recommended that fuse protection be added to the positive (+) input.
-
Ensure the intended area for mounting is large enough to fit the light and bezel per the dimensions shown in figure 1.
*Ensure the area behind the light is sealed location.
Figure 1 -
The wire exit is centered in the light. First mark the location on the mounting surface for wire entry. A 3/8” diameter hole is recommended for wire entry. If mounting to a metal ceiling material, ITC recommends using a protective grommet to protect the wires from cutting or fraying over time. Hole size may need to be larger depending on use of grommet.
-
Place light over wire entry hole and use the mounting screw holes as a template to mark the locations of the 2 screw locations. ITC recommends a #8 Pan head screw for mounting.
-
Make wire connections to vehicle wiring system using the diagram.
See wiring diagram
Wiring Diagram -
Secure light to ceiling using customer supplied #8 pan head screws
See figure 2 -
Snap the bezel into the mounted light assembly. Ensure all snaps have fully engaged to secure bezel to the light.
See figure 3
For warranty information please visit www.itc-us.com/warranty-return-
policy
DOC #: 710-00097 • Rev B •11/16/2022
3030 Corporate Grove Dr.
Hudsonville, MI 49426
Phone: 616.396.1355
itc-us.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>