OUTDOOR TECH Chips Ultra True Wireless Helmet Audio Instruction Manual

June 3, 2024
OUTDOOR TECH

OUTDOOR TECH logo CHIPS® ULTRA TRUE WIRELESS HELMET AUDIO
Instruction Manual

Chips Ultra True Wireless Helmet Audio

OUTDOOR TECH Chips Ultra True Wireless Helmet Audio -
icon

OUTDOOR TECH Chips Ultra True Wireless Helmet Audio -
icon1 Good call on picking up the Outdoor Tech® Chips® Ultra true wireless helmet audio. Your experience of the universe will soon be enhanced. This manual exists to help make sure that you use them correctly, so you’re definitely going to want to relax for a hot second and look through this.
Kisses,

WHAT’S INSIDE

  • Left and right helmet audio
  • Charging case
  • Charging cable
  • Instruction manual
  • One ODT sticker

ANATOMY

A. Left ear button
B. Right ear button
C. LED light
D. Microphone
E. Hi-Fi Speakers

FUNCTIONS

OUTDOOR TECH Chips Ultra True Wireless Helmet Audio -
icon4

FUNCTION EARPIECE ACTION
Power On LEFT 4 Long press for 3 sec
Power On RIGHT Long press for 3 sec
Power Off LEFT Press and hold for 4 sec
Power Off RIGHT Press and hold for 4 sec
Answer RIGHT Short press once
Reject RIGHT Long press for 2 sec
Hang Up RIGHT Short press once
Play RIGHT Short press once
Pause RIGHT Short press once
Skip Forward RIGHT Short press twice
Skip Backward RIGHT Short press three times
Raise Volume LEFT Short press once
Lower Volume LEFT Short press twice
Siri/Voice Activation RIGHT Long press 1 sec
Reset Chips Ultra/ Clear BT Memory Refer to the paper insert in the box for

instructions

CHARGING-THE CASE

Charge up the case so you always have power for your Chips® Ultra on the go.
Once the charging case is plugged into the microUSB, the indicator light on the front will turn RED- (CHARGING). It will turn GREEN once the case is completely
charged.
Case total charging time: 2.5 hours to fully charge the case.

OUTDOOR TECH Chips Ultra True Wireless Helmet Audio -
1

CHARGING-THE CHIPS

Charge your Chips® Ultra on the way to the hill, instead of having to plug them in the night before.
Gently plug the three holes on the side of the Chips® Ultra into the three prongs in the charging case.
Be sure to put the Left Chip in the Left side and the Right Chip in the Right side in the charging case.
The LED lights on both Chips will be RED – (CHARGING). Once both LEDs go off the Chips are fully charged.
Chips® Ultra total charging time: About 2 hours

PAIRING

POWER ON THE RIGHT
(long press 3 seconds)
VOICE PROMPT: “power on >> battery level >> pairing”

Choose: “ODT Chips Ultra” in your phone’s Bluetooth settings. VOICE PROMPT: “device connected”

POWER ON THE LEFT (long press 3 seconds) VOICE PROMPT: “power on >> connected”

OUTDOOR TECH Chips Ultra True Wireless Helmet Audio -
icon8 MUSIC FUNCTIONS

FUNCTION ACTION
POWER ON long press 3 seconds
POWER OFF Press and hold 4 seconds
PLAY short press 1x
PAUSE short press 1x
SKIP FORWARD short press 2x
SKIP BACKWARD short press 3x

PHONE FUNCTIONS

FUNCTION ACTION
ANSWER CALL short press 1x
END CALL short press 1x
REJECT CALL long press 2 seconds
SIRI / VOICE ACTIVATION long press 1x

VOLUME CONTROLS

FUNCTION ACTION
POWER ON long press 3 seconds
POWER OFF Press and hold 4 seconds
VOLUME UP short press 1x
VOLUME DOWN short press 2x

PUT THE CHIPS ULTRA IN YOUR HELMET

OUTDOOR TECH Chips Ultra True Wireless Helmet Audio -
7

  1. Drop the CHIPS® Ultra into the slots inside your helmet liner.

  2. Rock out, make calls, and, you know, ski and snowboard and whatnot.

SPECS

Bluetooth version: Bluetooth 5.0+ EDR
Bluetooth profiles: A2DP, AVRCP, HSP, HFP
Driver units: 40mm Neodymium magnet
Frequency Response: 20~20,000 Hz
Impedance: 32 + 32 ohms
Sensitivity (1kHz): 110 dB
Range: Up to 10m/33ft
Microphone: Built-in microphone
Battery: 3.7V, 250 mAh
Charging time: About 2 hours
Play / Talk time: Up to 13 hours
CHARGING CASE
Charging time: 2.5 hours (DC 5V 1A)
Battery: 3.7V 2000 mAh

OUTDOOR TECH Chips Ultra True Wireless Helmet Audio -
icon12 CARE & MAINTENANCE

  • Keep the Chips® Ultra away from direct sunlight or hot places. High temperatures will shorten the life of electronic devices, destroy the battery or distort certain plastic parts.
  • Do not try to disassemble the CHIPS® Ultra.
  • Do not let the Chips® Ultra fall onto the floor or other hard surfaces. The internal circuit board may get damaged.
  • Do not use intensive chemical products or detergent to clean the product.
  • Do not scratch the surface with sharp things.

WARNING: For safety reasons, some state and local laws prohibit the use of headsets when operating a bicycle. Use Chips® only for off-highway activities. Do not use Chips® at excessive volumes because it may cause permanent hearing damage.
Caution: The user is cautioned that changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules and Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions:

  1. this device may not cause harmful interference, and
  2. this device must accept any interference received, including interference that may cause undesired operation.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and receiver.
  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help.

FCC& IC Radiation Exposure Statement: This equipment complies with FCC and Canada radiation exposure limits set forth for an uncontrolled environment. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
DON’T BE SO ANTISOCIAL

OUTDOOR TECH Chips Ultra True Wireless Helmet Audio -
icon13

Facebook.com/outdoortechnology
Twitter & Instagram: @outdoortech
Questions, comments, complaints, secret desires, or just to say what’s up: email info@outdoortech.com
K bye.

OUTDOOR TECH logo outdoortech.com

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

OUTDOOR TECH User Manuals

Related Manuals