rossmax V3 Smooth and Comfort Suction Unit User Guide

: June 3, 2024
: RossMax

Table of Contents

Product identification
Assembling Procedures
Documents / Resources

Suction unit
Model: V3
Quick Guide

Product identification

rossmax V3 Smooth and Comfort Suction Unit - FIGURE 14

Suction unit
On/ Off switch
Vacuum flow adjustment knob/ vacuum regulator
Vacuum gauge
Canister “VACUUM” inlet
Canister “PATIENT” inlet
Collection canister (1,400 ml)
Tubing holder
Accessory compartment
AC/DC switching adaptor/ AC adaptor
Canister lid
Overflow valve
Air inlet
Connecting silicone tubing (Ø8 mm, 14 cm)
Antibacterial filter
Connecting PVC tubing (Ø1/4″, 180 cm)
Disposable manual regulator (Single use)
Disposable suction catheter (Single use)

Note: Disposable manual regulator (17) and Disposable suction catheter (18) are not supplied by Rossmax.

Assembling Procedures

| Connect one end of the connecting silicone tubing (Ø: 8 mm, L: 14 cm), with the antibacterial filter marked “IN” side, to the canister VACUUM inlet marked in Yellow
---|---
rossmax V3 Smooth and Comfort Suction Unit - FIGURE 2 | Connect the other end, with the antibacterial filter marked “OUT” side, to the “AIR INLET” connector marked in Yellow of the suction unit
| Connect the connecting PVC tubing (Ø: 1/4”, L: 180 cm) to the canister “PATIENT” inlet
| Connect the AC adaptor

Setup Before Use

rossmax V3 Smooth and Comfort Suction Unit - FIGURE 5 | Plug the AC adaptor into the socket. Place the switch to the “I” (ON) position
---|---
| Collapse the tubing and check the vacuum gauge to test that the level varies when the vacuum regulator is acted on. Adjust the level of vacuum prescribed by the doctor turning vacuum regulator.
Note: Turn the regulator clockwise, in the “+” direction to obtain a higher vacuum; or anticlockwise for a lower vacuum
rossmax V3 Smooth and Comfort Suction Unit - FIGURE 7 | Place the switch to the “O” (OFF) position

Starting the Suction

rossmax V3 Smooth and Comfort Suction Unit - FIGURE 8 | Connect the suction catheter to the connecting PVC tubing (Ø: 1/4”, L: 180 cm)
---|---
| Switch on the unit (ON/OFF switch)
| Place your finger on the manual regulator to activate the suction
| After application, switch off the device and remove the AC adaptor from the socket
rossmax V3 Smooth and Comfort Suction Unit - FIGURE 12 | Open the collection canister
| Remove the overflow valve(12) from the canister lid (11). Remove the rubber valve and float (12a) from the overflow valve (12)

Warranty Card
This instrument is covered by a 2 year guarantee from the purchase date. The guarantee is valid only on presentation of the guarantee card completed by the dealer confirming purchase date or the receipt. Suction unit accessories are not included. Opening or altering the instrument invalidates the guarantee. The guarantee does not cover damage, accidents or noncompliance with the instruction manual. Please contact your local seller/dealer or www.rossmax.com.
Customer Name: _____
Address: ____
Telephone: __
E-mail address: ___
Product Information
Date of purchase: __
Store where purchased: __

WARNING: The symbol on this product means that it’s an electronic product and following the European directive 2012/19/EU the electronic products have to be disposed on your local recycling centre for safe treatment.

Rossmax Swiss GmbH,
Widnauerstrasse 1, CH-9435 Heerbrugg, Switzerland
OBM_QG_SUV3
V18_ver2138
IN0XXXXX0000000XX

Documents / Resources

| rossmax V3 Smooth and Comfort Suction Unit [pdf] User Guide
V3 Smooth and Comfort Suction Unit, V3, Smooth and Comfort Suction Unit, Comfort Suction Unit, Suction Unit, Unit
---|---