RUNGU Dualie Chainguard Instruction Manual
- June 3, 2024
- RUNGU
Table of Contents
RUNGU Dualie Chainguard Instruction
Tools required
- 4 mm Hex Wrench
- 8 mm Hex Wrench
- Park Tool CCP-22 Crank Puller, or equivalent.
- Chain whip – suggested purchase
- Bike Chain master link pliers – suggested purchase
Removing the right crank arm
First, rotate the chain so that you find the master link on the return side
(bottom) of the chain. Use the master link pliers to compress the master link
and disconnect the chain.
Drape the upper length of chain over the chainstay as shown below.
Use the 8mm hex wrench to unscrew and remove the crank arm bolt
Install the crank puller into the crank arm.
CAUTION: BE CAREFUL TO NOT CROSS THREAD THE CRANK PULLER MOUNTING NUT
INTO THE CRANK ARM. FAILURE TO DO SO MAY DAMAGE THE CRANK ARM. CROSS THREADING
IS NOT COVERED BY MANUFACTURER’S WARRANTY.
CAUTION: MAKE SURE CRANK PULLER MOUNTING NUT IS AT LEAST FIVE (5) THREADS
DEEP INTO CRANK BEFORE TAKING NEXT STEP.
Rotate the crank arm puller clockwise to remove the crank arm.
Unscrew and remove the crank arm puller from the crank arm.
Installing the chainguard
Use the chain whip to stabilize the chain wheel and use the 4mm hex wrench to
loosen and remove each of the five screws holding the chain wheel to the motor
.
Place one of the M5x14 screws with a split washer through the chainguard and
chainring.
Align both with a mounting hole on the motor, install and finger tighten the
screw.
Install the next screw and split washer into a mounting hole on the opposite
side of the spindle.
Finger-tighten the second screw, then install and finger tighten the remaining
three screws and washers.
Use a 4 mm hex wrench to hand tighten each screw in a crossing pattern
Finally use the chain whip to secure the chainring and fully tighten each
screw using the same crossing pattern.
Replacing the crank arm and chain
While holding the left-side crank arm vertically, install the right crank arm
180 degrees opposite the left-side onto the square shaft.
Insert the crank arm retention bolt and begin threading it into the drive
axle.
Use the 8 mm hex wrench to fully tighten the crank arm retention bolt to the
drive axle.
With the crank arm in place and fully tightened, drape the drive side (top)
chain over the top of the chainring.
Use the master links to reconnect the return side (bottom) of the chain.
Use the master link pliers to spread the master links and snap the master link
in place
References
- Amazon.com : BIKEHAND Bike Bicycle Chain Master Link Pliers Tool - MTB Road Quick Link Remover Removal - Compatible with All Brands: Shimano Sram KMC Chain : Bike Tool Kits : Sports & Outdoors
- Amazon.com : BIKE HAND Compatible with Shimano Sram Freewheel Turner Install Removal Chain Whip Tool Kit - Cassette Remover - MTB Road 8 9 10 11 12 Speed : Sports & Outdoors
- Amazon.com : Park Tool CCP-22 Crank Puller : Bike Hand Tools : Sports & Outdoors
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>