LENNOX LB-101063C GFI Receptacle Kit Instruction Manual
- June 4, 2024
- Lennox
Table of Contents
©2022
PACKAGED UNITS KITS AND ACCESSORIES
506211-02
5/2022
Supersedes 10/2021
GFI RECEPTACLE KIT
INSTALLATION INSTRUCTIONS FOR GFI KIT (LB-101063C & D; 74M70 & 67E01) USED ON PACKAGED LG/LC/LH/LD/KG/KC/KH UNITS AND ELITE COMMERCIAL SPLIT SYSTEMS
Shipping and Packing List
Package 1 of 1 contains:
1 – GFI Receptacle J117
1 – Handy box
1 – L bracket
1 – Bag assembly containing:
4-1#10-32 x 1/2 TFS screws
WARNING
Improper installation, adjustment, alteration, service, or maintenance can
cause property damage, personal injury, or loss of life. Installation and
service must be performed by a licensed professional HVAC installer or
equivalent, service agency, or gas supplier.
CAUTION
As with any mechanical equipment, contact with sharp sheet metal edges can
result in personal injury. Take care while handling this equipment and wear
gloves and protective clothing.
WARNING
Electric Shock Hazard! – Disconnect all power supplies before servicing.
Replace all parts and panels before operating. Failure to do so can result in
death or electrical shock.
Application
The GFI Kit is used on LG/LC/LH/LD 024−360, KG/KC/ KH 024−300S, and Elite
split system units (ELS072-240, ELP090-120, EL072-240_C, EL072-120_P).
Installation
-
Disconnect all power to the unit.
-
Open or remove the compressor access panel. For Elite split system units, remove the control box cover.
-
B and C Box Units − No Wiring Make−Up Box − Use L−bracket as a guide to mark and drill holes on mullions as shown in figures 1 and 2. Install L− a bracket on the inside of the mullion. Secure bracket from outside of the unit.
-
Elite Split System units only:
Remove the control box cover mullion. Place the handy box on the power entry panel as shown in figure 6. Drill holes and secure the handy box using #10 screws provided. -
All other units: Install handy box in the following locations: (See figure 3.)
• Figure 1 B Box units
• Figure 2 KG C Box units NO wiring make−up box
• Figure 4 A Box units
• Figure 5 C and D Box units with wiring makeup box
NOTE − Use #10 screws to secure the handy box to the unit.
Make sure screws do not damage wiring.
-
Route field−provided wiring through the conduit and appropriate knock−out in a handy box. Connect wires to terminals on the back of the GFI receptacle according to the wiring diagram on unit and local codes.
-
Secure GFI receptacle to handy box with 2 screws provided with the receptacle.
-
Install GFI faceplate on receptacle; screws and faceplate are packaged with the receptacle.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>